If I was to buy the 12g cdh rims like GW has is there anyway possible I could get one of these products so that it will offset the chain alignment with the engine? I don't know how to re dish the rims like GW did. I did some measuring and if I get those rims and use the disc brake mount for a 36 tooth sprocket it will set to far out by almost half a inch or less. Seems like if I get one of these with it it will offset it enough so the chain would be in line with the engine sprocket. Any... Read more ..read more

Welcome everyone, I recently put together another 2 stroking motorized bike (100cc) and had the worst time doing so. Two months ago, I’ve run into a huge problem that I need help with. The chain on my bike wobbles way too much and skips when the engine is idling. It's pretty much annoying because I want the bike to run smoothly at all times. Here are a few details that might help figure out the issue: The chain is brand new and well-lubricated. I’ve checked the alignment multiple... Read more ..read more

Is there a belt reduction transmission that will fit a Huasheng 38cc engine (Honda GX35 clone ..read more

i've got maybe 400 miles at most on this engine. what's causing this thing to wear out so quick? anybody had this problem and fixed it? or should i stock up on bevel gears ...... my crank isn't balanced and i never cracked the bottom end when i put it together. maybe the clutch or crankshaft are sloppy and wobbling around? i've noticed the teeth on it getting sharper for a while. i've greased it a few times but it doesn't seem to do a lot, the grease just gets flung all over the clutch... Read more ..read more

So I got a jack shaft kit and the freewheel that came with it has threads that don’t fit a little black piece which I’ll attach a picture of below. The bike is a fat tire bike. What can I do now ..read more

This is an update on an old thread of mine 'Rear wheel spins fast at idle'. After a break, I got back to the bike and noticed that the clutch is in crooked!! A puller just arrived - headed out to see what the heck is going on ..read more

Dear Fellow Gearheads, My second build is a 66cc Hyper Cruiser with 46 miles on the odo. I installed a high quality rim brake on the front to assist the coaster brakes. After noticing that the rear hub was warm to the touch, I also noticed that rotating the rear wheel with the clutch disengaged caused the pedals to rotate. I knew that this meant that the rear wheel cone bearings were a tad tight. I removed the wheel from both chains and loosened the bearings until there was a little... Read more ..read more

Can I maybe get one of you guys to possibly send me a picture and show me exactly where I'm supposed to put the red tacky clutch Grease please and thank you sir ..read more

Finally listened on here and think it's time for a new clutch for my Huasheng 49cc. Ordered two, neither was correct. Eventually I'll find the correct one. But how the heck do I get the old clutch out? You Tube was no help at all. Thanks, Bill ..read more

I'm looking for a hub/sprocket adapter to fit a 1.25" (32mm) hub that can work with the standard 9 hole steel sprocket ..read more