Boat Repair Forum » Volvo Penta Gas Engine
7 FOLLOWERS
MarineEngine is a boat repair discussion forum for do-it-yourself boat repair. Get boat repair tips, find helpful guides for the right boat parts, ask questions, search for answers to your Volvo Penta engine temperature sensors-related problem, and find gas engine identification guides.
Boat Repair Forum » Volvo Penta Gas Engine
1d ago
I have a 2001 Ebbtide 201 bowrider and I cannot get the trim to work while the boat is in gear or moving forward. I'm thinking I should be able to trim everything while I'm running down the lake. Am I wrong or can anyone help me with this ..read more
Boat Repair Forum » Volvo Penta Gas Engine
4d ago
Boat won’t stay running. Cranks and fires, but immediately dies. Tried applying some throttle. Still won’t stay running. Seems like the fuel pumps are activating when I turn on the key, but not getting any pressure on the high side. Don’t have the adapter to check the low side. Been talking with a lot of people and everyone has some suggestions as to what to check. One guy said it might be the oil pressure switch. Seems like something is telling it not to start. Any suggestions ..read more
Boat Repair Forum » Volvo Penta Gas Engine
4d ago
I have a 1987 Sunrunner 20' boat with a DP-290 outdrive. The engine that was in the boat when I got it was a Mercury 5.0, 305 with a cracked block. What engine model should I search for AQxxx when looking for instructions. I am trying to figure out how to align the engine and outdrive. I have alignment tools for Mercruiser and OMC cobra and I know the procedure well. The DP-290 with a spline shaft in the boat and outside the boat is new to me. It has a electric fuel pump, I did a good...
Read more ..read more
Boat Repair Forum » Volvo Penta Gas Engine
4d ago
Hello everyone, New here so I apologize if this has been touched on before. I have a 1994 crown line with a DP-c1 outdrive and would like to replace the trashed engine with a 5.0 OSi-ff (2007). Will this work ? Thx in advance for any help ..read more
Boat Repair Forum » Volvo Penta Gas Engine
1w ago
Good day, captains! I own a Monterey 282 with two petrol Volvo Penta 4.3 engines. The starboard (STBD) engine sometimes has an issue with starting. The ignition turns, but when I push start, only the volt gauge moves, and nothing happens. After several tries, which can be anywhere from 5 to 50 attempts, it eventually starts.
Here’s what has been done so far:
New batteries
New start button
New starter
Positive cable from the main switch to the starter
New wire to...
Read more ..read more
Boat Repair Forum » Volvo Penta Gas Engine
1w ago
I have rebuilt 4.3L carb engine from 1995 boat. and Have a chance to buy a 2005 boat with cracked block 4.3L carb with volvo drive. Are the blocks the same? or same bolt pattern for the drive? I just want to swap the engines ..read more
Boat Repair Forum » Volvo Penta Gas Engine
2w ago
Can anyone help with finding a clutch package for a 1958 Volvo Penta BB70in a Storebor Vindö ? I kind find any identifying information on or in the gearbox. Would also really appreciate technical descriptions for clutch adjustment. Thanks ..read more
Boat Repair Forum » Volvo Penta Gas Engine
3w ago
Hello all, I currently own a 96 Volvo penta with a sx cobra 1.66 outdrive and it is powered by a 5.0fl v8.
The other day when I was out on the lake it started to make this grinding swirling sound when I put it in fwd or reverse gear and it would get a bit louder and vibrate when at cruising speeds and will go away at higher speeds. I decided to check the gear oil and it appears the magnet in the drain plug broke and there is small metal chunks stuck to it. I checked the inspection port on...
Read more ..read more
Boat Repair Forum » Volvo Penta Gas Engine
3w ago
Hello,
I have the gear oil drained and wondered if anyone has ever used a solvent to flush out their drive case unit before refilling with gear oil? Seems like a good idea to me to clean out the gear case ..read more
Boat Repair Forum » Volvo Penta Gas Engine
3w ago
Hello everyone,
I have taken over a project that I could really use some help with.
The boat is a 2011 with a pair of 5.7's and the EVC-C3 system with electronic steering
Engine Serial Numbers A112918 and A112917
The previous shop was trying to fix a steering issue and replaced the SCU. From what I can tell, the part number is correct (23097949) but there seems to be a calibration issue as it is now calling for the HCU software to be upgraded.
It is currently not steering with the active...
Read more ..read more