Replacing a frozen throttle cable and I don't want to have to remove the shifter controls and gas tank to get to it. Is there a better way? The existing cable goes through, and appears to be attached to, a plate under the shifter controls. Can I just run it through that area? The new cable came with a wire tie but no instructions. I have it disconnected on both ends but cannot pull it through ..read more

I am in need of front axles and see some very tempting prices from companies like Niche...etc. But I really only want to do this once and not deal with a torn sub standard boot in 3 years on my 1993 Cdn spec Quad Runner 300. Is there a known company for this part with a good rep? Tia ..read more

I need to replace the crank seals and don t know how to remove the clutch. Any help out there ..read more

Hi this is my first time here. I'm working on a 1997 suzuki king quad 300 and I runs like crap. I stated out by cleaning the carburetor I did that about 10 different times putting the air system back each time it still ran like crap. After that I replaced the fuel pump and lines still didn't run right. Then I replaced the stator and spark plug and it's still not running right. But ever time I put a bigger battery out of a car it runs fine, idles fine, revs up, and I can drive it but when... 1997 suzuki king quad 300 wont run right ..read more

I have two older quads that I think are the same year. The vin on one is impossible to read and on the other it's rusted and hard to read but near as I can tell it is: JSAAJ45A2H7114107 (after the H it's questionable). I got that it is an 87 but what model and engine? I need an upper ball joint; are they all the same or dependant on model & year? Best place to buy them ..read more

I had some mice get in my 2013 kingquad 750 axi w/ power steering and chew up some wires on the power steering control module. I have soldered the wires back together twice but nothing last, they chewed them off right at the base so there is not much wire to work with. I have been looking on eBay, does anyone know how compatible the 500 module and 750 module are. It seems the numbers vary a lot. The last 4 of my bike are 31g00, I see a lot of 31h00 just not sure what the difference is. Also... Power steering control module ..read more

Hi there, I recently bought a 2005 King Quad 700 from a friend, it's in questionable condition overall but seems to run pretty good. As I disassembled all the plastics and serviced everything as well as changed some cv boots I also noticed that it looks like the frame is slightly twisted, the rear wheels both lean in the same direction, one has positive camber and the other negative. From what I can tell it doesn't affect much and everything is free to move as it should and works as... Engine oil classifications meaning ..read more

hello first time posting here but i have use these forums for this entire project and they have been nothing but helpful. this is also my first atv that i have worked on at all. i have alot of mechanical experience but nothing too extensive. mostly external engine work, not much internal. anyway i have a 1998 suzuki kingquad 300 that i bought of marketplace for 600$. it was a great price (1000-1500 for a nice running one near me) and i knew it would need work. so far i have replaced a... 1998 suzuki kingquad 300 topend rebuild help/advice ..read more

Hey all, new member here. Picked me up a new 2023 Kingquad 750 about a month ago, absolutely loving the machine except for this annoying exhaust chirp it has, particularly noticeable on cold cranks. It seems to go away when the motor is nice and warm, although it’s still slightly there. It only does it at the end of a rev. I’ve banged on it here and there to see if I could replicate the noise but i can’t get it to make the noise that way. Anybody else have this issue ..read more

2000 Quadmaster LTA500F. Looking for some advice. 4WD is damaged and will not engage, problem is internal to the diff, not linkage. Probably happened when I hit a low spot in a creek on accident, water to the bars, and had to continue to ride. There was other very muddy excursions before that. About a month after that and some heavy riding I drained to find only water in front diff. Flushed and filled but no dice. I removed the cover where the 4WD linkage attaches and man... muddy and... Grenaded 4WD in Quadmaster Front Diff ..read more