Gulf Coast Gun Forum » Gunsmithing
27 FOLLOWERS
This is a community for Gun Owners of the Gulf Coast States to discuss Gunsmithing. Stay updated on firearm-related events, share photos and videos of firearms you own with other members, and chat with local firearm trainers.
Gulf Coast Gun Forum » Gunsmithing
2w ago
Anyone know whether it's possible to convert say a certain ria hc 10mm to 38 super?
I already know they use the same slides on the single stack (breech face for 38 super is slightly bigger than 9mm so factory convertible guns use the bigger 40 s&w slide for ria at least don't ask how I managed to find that out).
Basically just curious if anyone's done it and if not then well now I gotta find a barrel and already got the Para 38 super mags sitting in a shopping cart ..read more
Gulf Coast Gun Forum » Gunsmithing
2w ago
CZ 455 FS (Mannlicher stock version) threading service – Tornado Technologies
tornadotechnologies.com
I’m wondering if there is anywhere in the panhandle that’s capable of doing this ..read more
Gulf Coast Gun Forum » Gunsmithing
3w ago
I am looking for a stainless 454 casull 20 inch magazine tube, does any one have one of these ..read more
Gulf Coast Gun Forum » Gunsmithing
1M ago
New trigger shoe installed , although the trigger won’t reset unless I re-rack the slide 2 or 3 times.
How to fix? Thanks ..read more
Gulf Coast Gun Forum » Gunsmithing
1M ago
Seen this on another site LMFAO I hope this is real ..read more
Gulf Coast Gun Forum » Gunsmithing
1M ago
The S frame dagger ( G17 grip) fit on the upper but the trigger wouldn't reset. The older dagger lower worked fine. (G19 grip size) Wondering why???
G19 lower works fine on it. Recently got the g flex trigger and am considering putting it on the dagger frame. Won't know if it work with the mt upper till I get home in June.
Hopefully it will work and I can put the comp back on the dagger upper for extra fun ..read more
Gulf Coast Gun Forum » Gunsmithing
1M ago
I have a gen 3 Noveske N4 that has a KAC rail on it, and I’m wanting to go back to an NSR, but I don’t have the old one. If I buy a gen 4 NSR, is the receiver still going to match up to the forend? I’ve been searching and can’t find a 13.5” gen 3 anywhere ..read more
Gulf Coast Gun Forum » Gunsmithing
2M ago
I have a KDS9c, a ds 1911 with an external extractor. When trying to unload a live round it gets stuck, can't manually cycle it. It takes several hard pull/jerks and there have been a couple times I was unsure I would get the round out. Only with live rounds, dummy rounds work fine. If you use the same round over and over, it's gets easier, use a new round and back to the same.
Magazine in or out makes no difference.
Using S&B and Fiocchi factory new 115 & 124 all have the same result...
Read more ..read more
Gulf Coast Gun Forum » Gunsmithing
2M ago
So out of curiosity since I've seen the 20 and 12 gauge side by side to each other and the receivers look about the same. So would a 12 GA mossberg 500 barrel fit and function on a 20 gauge ..read more