Hey guys im new here. Just got this 2001 warrior 350 the other day, i knew it didnt run and got a good deal on it. When i got there the dood swore it had spark just the other day but now it didnt for some reason. I took his word and got it. Took it to a buddies shop and sure enough this time when we tried, it did in fact have spark. Good spark. So we pulled the carb and cleaned it out. Still wouldnt start but still had spark. Did a compression test and only has like 70psi. So i pulled the... 2001 warrior 350 had spark now it dont ..read more

Hello everyone. New to owning a warrior and trying to get it to run. When we first got it- we could not get it to start so we bought a new wiring harness and replaced it. Now that we’ve replaced it- we tested it with an ohmmeter and it’s saying we have a short somewhere but not a clue where. Everything we’ve taken apart and put back together matches up perfectly. Any ideas ..read more

Newbie ..read more

Ok gang looking for some info and help I have a 93 that starts and runs fine if I put my. jump box on the new battery. After I take it off it still runs, I can ride it and it runs great, if I turn it off it will restart without the jump box but after about 5 minutes of sitting it won't start without the jump box. I have had this happen before with other machines (as I like to fix up old Warriors and resell them) and a new coil always fixed the issue but this time I am on my 3rd coil and the... Warrior Ignition issues ..read more

Hello to you all! I have a 96 warrior that I just did cam and big bore kit on. Problem is that suddenly it will only start cold if it is hooked up to a jump box or jumper cables. Then it'll pop right off. Without the jump box it'll just crank and crank but not fire. When it's warm it will start right up without a problem. Kind of at a loss as to where to go. It does have spark and fuel on a cold start. Timing seems to be correct. I appreciate any help you guys can offer ..read more

Referring to: http://www.bluetraxx.com/forums/yam...resent/90922-1987-warrior-350x-need-help.html Still no spark after changing everything electrical except harness. Found out that the wires were bad in the cutoff switch and were not making contact all the time, so got a new one and fixed it. Now I know you can't really test a CDI BOX, but i tried the following test just to see the results. Multimeter 20k volts: POS to cdi orange wire - NEG to Coil... '87 yamaha warrior no spark issue ..read more

I got a full dg exhaust system for my 1989 Yamaha warrior 350 and it’s running so lean it will start and then die, just need help with adjusting the carb, thanks ..read more

Still no spark. I'm totally stumped with this thing, I’ve tried/checked everything, ohmed out wires, nothing I do seems to work, I'm not even getting any spark what so ever now. Bought an aftermarket stator, same ohm as stock one. Any advice would be greatly appreciated. Thanks in advance ..read more

I've been told it has a cut out encase the thumb throttle is blocked and the throttle stays on that's shrewd it will cut out. Would it cause the new motor to not start ..read more

Hello, I have a 2002 Warrior and I have done some research about the electrical problems that come with the warrior but this is a whole different problem that I'm not sure most will have an answer to. I have done a decent amount of electrical work on the warrior and am co confused on whats going on. Problem: Turned the quad on and put the key in turned it on, then flipped the switch to run clicked the starting button, nothing no click from solenoid or anything of that sort. Tried the... 2002 Warrior 350 Electrical problem - Lights will come but wont start ..read more