Hello guys ! Im looking for a 3D file to print a Helmet shroud (military L4g24) to googles 2. Some exists, as shown there but cost a fortune. submitted by /u/ColdAssociate337 [visit reddit] [comments ..read more

submitted by /u/Nice-Alternative-297 [visit reddit] [comments ..read more

Looking for any support on the P1S with smooth PEI Plate. I changed from textured to smooth because of adhesion issues and it fixed it for about a week. Now I can’t get large or small parts to stick to the bed. I have tried cleaning it with dish soap and warm water and clean with IPA between each print. Bed is not warped. Printing PLA on generic PLA settings except for I have 60° bed. submitted by /u/gavinthacyk [visit reddit] [comments ..read more

been thinking of dipping some of my finished prints in paint for a cool design. the filament i wanna use is TPU, i want to dip the whole print in paint and then dry it somewhere. anyone got any idea how i can speed up the drying and curing process? i want it to take at most a day. i'm getting from some results it takes like 30 days or 3-4 weeks. thanks and good day submitted by /u/MajorBeing3071 [visit reddit] [comments ..read more

submitted by /u/AssassinGamer_ [visit reddit] [comments ..read more

Trying to paint red over grey PLA, are acrylic paint markers a good option? submitted by /u/Eclipse8301 [visit reddit] [comments ..read more

My issue: I bought the original Elegoo Saturn (with a 4k display) in 2021 and it has been collecting dust since, because it had serious elephant foot issue and layer squashing issue which made it unusable for functional part prints. I asked on reddit back then and was told the issue is at the firmware level and can't be fixed unless Elegoo themselves bother fixing their firmware. I didn't have the time to have a discussion with a cheap and slow tech support so I just got an Anycubic Photon Mono X and used that for 3 years. Not a great printer either, the motherboard died once and and the LCD ..read more

submitted by /u/lentaoshaman [visit reddit] [comments ..read more

My 3dtouch is only leveling the left side of the bed, it probs all spots of the bed, but when it prints, only the left side is leveled, making the printing come off the bed on the right side. I use marlin 2.1 (Configured to BLtouch and any), i tried using other firmwares to fix it, but issue remains. My printer is a Ender 3 The z probe was set before running the print, i also tried to level and the bed manually on the screws and also didn't work submitted by /u/ConfusedDove [visit reddit] [comments ..read more

submitted by /u/According-Monk-6622 [visit reddit] [comments ..read more