Are your 2002-2009 Toyota 4Runner seats looking a bit worn out? It's time to give your ride a fresh look with our OEM leather replacement seat covers! We offer 100% authentic leather seat covers, and you can choose from Genuine Leather, Napa Leather and Suede Which one would you prefer for your 2002-2009 Toyota 4Runner? Check out our website to see more details and order your new seat covers today. Give your 2002-2009 Toyota 4Runner the upgrade it deserves! Share your thoughts... Read more ..read more

I just acquired a set of front OME BP51 shocks for the 4Runner. The hardware for the top hats is missing, the bolts to mount to the shock tower. Does any know the thread pitch for the bolts ..read more

Hello everyone hoping to get some input here or anyones 2cents as its the weekend and every shop is closed. i just swapped in a 8inch elocker out of a fj cruiser. i had a shop rebuild the diff and do all new bearings etc. e locker harness is from trail gear, all plug and play. i installed said rear axle and have noticed its stuck in the locked postion. i have put the car in neutral and messed with it slowly creeping forward or in reverse slightly turning to try to get it to unlock and only... Read more ..read more

Has anyone towed (or have thoughts on towing) a ‘92 FJ80 on a tow dolly with a 5th gen T4R? It would be about 3 hours drive time and quite flat. No mountains or anything. My only hold up is how unbelievably soft these suspensions are. But it also wouldn’t have much tongue weight. I know braking would have to be done with much more advance notice. I have a CDL so am used to larger loads, just not on such a small vehicle ..read more

Hi yall, I drive a 2011 4Runner with a 3" lift on 33s. I recently picked up a 1998 3rd gen 4Runner as well! Here are the two beauties next to each other. My 3rd gen need some work, so I'll hopefully be around on the forums ..read more

I look forward to getting to know some of you at an event one of these days. I enjoy trail riding, rock crawling and getting muddy ..read more

Just got a new 1987 mint 4Runner. Rear leaf springs are sagging. Was going to get a new set of OME springs that claim to have a 2" lift. New Bilstein shocks all around too. Will I also need to add a set shackles to the rear? Hoping I don't have to, but do I need to also mess with the front, add a set of ARB Front Torsion bars or 2" front spacers? Hoping I can just add the new OME rear springs and shocks and be GTG! Thx ..read more

This tutorial gives a step by step for installing a 1/2" Cornfed (or other brand) front spacer (aka leveling kit) on a KDSS equipped 5th Gen 4Runner. A 1/2" front spacer will yield a 1" lift due to the geometry of the front suspension. Rationale: I consider this 1/2" spacer, 32-33” A/T tires, and a proper skid plate to be essential mods on any 5th Gen 4Runner other than the TRD Pro. The TRD Pro sits 1" higher from the showroom floor, has Nitto Terra A/T tires, and has the more proper... Read more ..read more

Picked up another 4Runner...this one in a 2001 with only 150K miles on it. Pretty bone stock so I have gone through and replaced ball joints control arms and a few other things to get it ready for a 2" lift (seems all bilstien kits are on backorder). Anyway, I wanted to also put a new radiator in just to be safe and ordered what I need...all OEM. So when I went to take out the old one I noticed that someone had disconnected the transmission lines and just looped them so they did not run... Read more ..read more

Back on my daughter's rig. It seems as if the headlights have that dim yellow look to them. Any suggestions would be appreciated as the number of options out there are crazy ..read more