I have some Raptor 700 piggyback fully adjustable front shocks in perfect shape, both silver or SE black bodies with pre-load, high/low speed compression & rebound, your choice of color coils with brand new powder coating in gloss black, gloss Yamaha blue, gloss red and candy lolliepop red (like the frames on some Raptors), bolt right up to 700's & takes small mod for 660's, they don't have a scratch on them, I will take $325 shipped and will use priority mail 2/3 days and delivery... RAPTOR PIGGYBACK FRONT SHOCKS FOR 700/660 ..read more

I recently bought a 2003 that had a rebuilt motor with it, but was never installed or started. I installed everything and got all the wiring hooked up. It turns over with no issue, but won't start. After several attempts It had a small backfire when I let off the starter. I pulled the plug to check for spark and found that it only sparks when I let off the starter switch. Otherwise there is no spark while cranking. I ran through several tests with an ohm meter and everything appeared to be... No spark cranking except when I let off the starter ..read more

I saw that harbor freight had 3000 lb wireless remote winches on sale for $50 around christmas so i bought one. Then i decides to remove the stock bumper and fabricate a winch bracket. I made it out of 1/8 " plate steel angle iron and a 1 x 1 peice of steel. I didnt take any pictures of me making it becuse i couldnt find my digital camera. I have a few pics of before i had it powedercoated on my cell phone but the quality sucks. so i took the bumper down to the local powdercoaters shop... Winch on my Raptor ..read more

hello i have a 2008 raptor 700r and its been sitting for about 8 months but i had it running last months im trying to take it to winchester in two days but i cant if it wont run i have a bad solenoid so i replaced it and i got a new battery so it cranks fine but still wont start i can here the pump running when you turn the key and i checked the plug and it was dry so i sprayed some starter fluid on the air filter and it started right away but instantly died it has spark and a charged new... 2008 yamaha raptor 700R se crank but no start ..read more

Raptor 660 11:1 piston bored to 686 stage 2 cam and dual looney tunes exhaust elevation 10feet above sea level ..read more

Hello all sry for my english im french I'm desperately looking for someone who can make me a metal subframe Thanks a lot ..read more

Ill kick it off. I only have one right now but ill get more up ..read more

I've built numerous dirt engines across almost all of the manufacturers, i've bought case sets for replacment but never a half… Are the OE castings that accurate to buy just one half of a crankcase? Center case half, not a side or cover. Have a TRX450R here that needs hours of cleanup just to repair.. would rather buy a half if it is a good idea. Anyone have some experience here? Obviously engine serial numbers do not matter to the owner. Thank you ..read more

What you see is what you get. No engine. 1000 cash on low ball. Serious buyers only ..read more

Yamaha Raptor 660 valves adjustment Tools you need: 10MM socket 17MM socket 19MM socket Ratchet Breaker Bar (optional) 3" Extension (not shown) 4MM Hex Key 5MM Hex Key 10MM Key Needle Nose Pliers Yamaha Spark plug socket (not shown) Feeler Gauges Philip Screw Driver (or socket like on the picture) Service Manual for Torque Specs and Valves Clearance AND A STONE COLD ENGINE... Step-By-Step Valve Adjustment for Raptor 660 ..read more