First time opening pool without a company involved. Everything is going good in the pool however the spill over spa is not pulling water or returning. Photo of settings attached. First photos are pulled from pump. Photo 2 is returns submitted by /u/ekg0477 [visit reddit] [comments ..read more

submitted by /u/Rivadell [visit reddit] [comments ..read more

submitted by /u/Alphawrites [visit reddit] [comments ..read more

I've been fighting algae and performed SLAM. Hit cloudy pool again last night with shock and left pump on overnight on lower RPM. This morning and all day pool looks better and about 85% crystal clear. This afternoon run pump at high RPM to get water moving and every jet shoots out a white cloud and pool immediately is so cloudy you cannot see the bottom. Happen to anyone before? Is this dead algae or chlorine that was sitting in sand filter? FC is 11 CYA is 30 CC .1 PH 7.4 ALK 100 submitted by /u/billbratsky33 [visit reddit] [comments ..read more

submitted by /u/mphs2step [visit reddit] [comments ..read more

Taylor K-2005 and strips (sanity check) both show 7.5 FC right when I pulled the cover off. No discernable CC. 18k gallon pool. I closed the pool with 4-8 gallons of 12.5% liquid chlorine 8 months ago with a tarp cover. Water was max 60 degrees, mostly much colder. Am I missing something? Is this pool ready to swim? pH 7.4, Alk 95 submitted by /u/DeusExHircus [visit reddit] [comments ..read more

Hey everybody! I need help. I’ve got an 18” round Intex Ultra XTR with the sand filter. It’s just under 7000 gallons. This will be its 3rd summer. It opened pretty easily the past two years, I didn’t struggle like I am now. I can’t seem to get enough chlorine in it! I’ve triple shocked it twice, double shocked it once, and done quite a few single packs of shock. Both my pool strips and my big tester kit (it’s one of the nice Taylor kits, I think a 2006?) both are showing my free chlorine is 0.5ppm or maybe even less, and total/combined chlorine is about 1ppm. I triple shocked last night and t ..read more

I have the error E5 on my pool heater. Referred to manual and E5 is "Not failure, power supply excess operation range" Does anyone know anything about these heater that can help me out? Thanks submitted by /u/wigs100 [visit reddit] [comments ..read more

Anyone repair fiberglass pool in houston? submitted by /u/donoyet6969 [visit reddit] [comments ..read more

submitted by /u/cgstrmh [visit reddit] [comments ..read more