I have a garage setup with strict community water dumping rules. So I'm running my water for washout and reclaiming out of an ibc tote and trying to build a water recycling setup that's both efficient and will remove chemicals from degreasers and emulsion remover. My concern is both leaving chemical residue in the tank that will then run through my power washer as well as potentially ruining a newly burned screen. Notably I am using eco friendly, "drain safe" versions of both chemicals but I would still rather try and filter if possible for reasons. I've seen info saying anywhere from 0.5 to ..read more

Does anyone know if Arena Pre-burned screens (Arena prints) Ship to Australia??? Or is it only in the US, if it is only in the US, does anyone have any alternatives? Thanks submitted by /u/Garryzedd [visit reddit] [comments ..read more

Title, I’ve screen printed for the last couple of years in community college always with a multi colored press , I might not be able to afford to go back to that class this time but I have a old hand down press from a teacher which has multiple color arms , but no XYZ registration knobs or whatnot A lot of my designs used pretty thick outlines cus I draw cartoony characters , and I remember that once while doing a regular screen printing project I managed to finish it off because I just ended up eyeing and carefully lining up my screen with the layer below Couldn’t I apply the same idea to a ..read more

So water based ink recently clogged my whole screen and I was wondering what the best ink alternatives would be submitted by /u/Mammoth-Reading892 [visit reddit] [comments ..read more

submitted by /u/Chadbigears801 [visit reddit] [comments ..read more

Looking for any auto diamondback owners or experienced operators. I bought a used one and have a few questions about platens being replaced because of warping. Want to be sure it’s the platens that need replacing. Anyone with knowledge on the auto is appreciated it! submitted by /u/Foxmulder20359 [visit reddit] [comments ..read more

Can someone let me know if this quote is reasonable. 25 hoodies 10 tshirts 2 colors. I’m also providing my own blanks. I got a quote of $403 Front back design and small design on the sleeve submitted by /u/Alert_Development583 [visit reddit] [comments ..read more

Printing these shirts the customer brought with this convenient distressing location , straight nightmare printing these submitted by /u/Lickitrick [visit reddit] [comments ..read more

hey guys, someone to shade some light on the equipment requirements for someone just starting up. submitted by /u/Mweemba480 [visit reddit] [comments ..read more

I’m separating some artwork for a print. Currently my colors are Cool Grey 6C as the underbase and light greys, white to highlight, and cool grey 11C as the deeper greys (shadows are the shirt). I’m curious if anyone has experience with this and sets the halftones at different angles, currently mine are all set at 22.5 degrees. Thanks!! submitted by /u/fungun_01 [visit reddit] [comments ..read more