Hi Friends, This might not be the right place to post this but it seemed fitting, feel free to move this if necessary. I am in the middle building a tangential cutter from what once was a Queen Bee Pro kit. I am using all of the motors and drivers from that kit (ill detail it all below) but I have designed my own tangential cutting head with a servo and I am getting ready to wire everything up. I just finished assembling the electronics cabinet and attached is a breakdown of the components. I have a few questions that I'm hoping someone smarter than me can lend some insight on. The kit came ..read more

Hi, I have a ez-router scorpion cnc that has 5.1 Cuken planetary gearbox. I’m wondering if there are any alternatives that may work for me? To order one from ez-router is $1000. Ordering direct from the company in china is $189 + freight but it’s very hard to get ahold of them as you can imagine. Here are the specs of the gearbox http://www.precisiongearbox.com/html_products/PF80-SERIES-PRECISION-GEARBOX-SERVO-SPEED-REDUCER-133.html ..read more

Can a machine file be created from scratch ? Dose anyone have a generic Fanuc wire post for an Old control say 6m or a 0 controller . Thank you all ..read more

Hello New to the forum and hoping for some insight into a problem I've been having. I need to reset the Reference Position on my HAAS ST-20Y Bar Feeder and I hit a wall. The command G105 Q4 loads a bar, measures the bar, and pushes it just before the collet. After that, when all motion has stop, I'm suppose to hit "RESET" and that allows me to Handle Jog the V Axis(bar pusher rod). However that has not been happening. After hitting "RESET" no movement occurs when manipulating the jog handle(of course pressings what jog rate I want). There is no issue with the bar feeder itself that I'm awa ..read more

My father lost all the parameters off anyone have pls help me ..read more

Replacing main board. need procedure to load parameters and pmc from flash card. note: control powers up with a boot screen. 1. load sram data .2 save sram data. etc ..read more

Hi, I need a manual for the Arburg 750-210 320 D Injection molding machine. I am situated in South Africa hope someone local might have a machine like that. but any help will be appreciated ..read more

I have two (2) weldon endmill sharpeners that a highschool robotic team students dissembled to "see" how they worked. I need to reassemble them. The bearing has been removed from the frame. I had five (5) other spare bearings which they mixed up with the originals. Is there a way to reassemble these things ? I've heating the outer bearing to about 120 degrees with no joy. I'm not sure how hot I can get them or if this is the correct way to get them back together. Are they lapped to the spindle and only fit the original pair ? thx for any suggestions -g ..read more

I have a short when I plug in the input output boards it shuts control power off and now it has the 20 nmi alarm and has 225 percent on the Z axis load meter ..read more

Hi, I have recently bought a new spindle which has an HSK32 tool interface. I would like to move to shrink fit tooling, but cannot afford a machine to do so. Electronics is my thing, so I could entirely probably make my own induction heater. It sort of comes down to power, easy to make something up to 1kW lets say, but a damn sight harder to build something of 20kW. Does anyone know, or have experience, about the power levels required to make shrink fit tooling practical? Craig ..read more