I have a 06’ Sequoia Limited that the factory alarm randomly trips or goes off. Went months and it didn’t happen and the last two days it’s gone off at random times of the day. Car could be sitting cold for hours and randomly goes off ..read more

I just bought a 2002 Sequoia with 300k on it for 2k. On the dash where the 4x4 lights are in the middle of the 4 tires there's a circle light. That light will flash on and off the whole time the car is on. What is the cheapest way 1st to fix ..read more

Wondering if I'm crazy or what. I have a 2023 Subaru Ascent with 30k miles on it (already paid off). My family (me, wife, 4 kids, large dog) use it as a daily driver and for overlanding/offroading. We've been all over WA, cascades, mt rainer, Utah and several BDR trails with many more to come. We've done thousands of offroad miles on it. It has full skid plates, 2" lift, rock sliders, winch, swing-out hitch with full size spare, automatic rear diff lockers, prinsu roof rack, offroad... Going to a 2018 Sequoia Limited for Offroad/Overlanding (family of 6)? Coming from a 2023 Subaru Ascent ..read more

I have the 3URFE / 5.7 liter engine and OBD code p0328 on a 2008 Sequoia. - Does anyone know which KS is bank 1 / sensor 1? - Does anyone know proper resistance on a knock sensor for this engine? - Does anyone know if 0.2 Megaohms is a bad resistance reading for a knock sensor? I inspected the wire harness and no obvious fraying or broken wires. I tested the resistance on all four sensors and all four read 0.2 megaohms. I’d hate to have to swap them srpund to pinpoint which is bank... Knock Sensor Code 0328 ..read more

I have had two oil filters collapse in less then two months. I was taking my vehicle to a local garage and had my oil changed and my oil pressure dropped to nothing. I took it back to them and they told me that it was the oil filter that was crumbled. They changed the oil and it was back to normal. Then about a month later my check engine light came back on along with blinking vsc and a few others. I took it back and they said it was reading only 3lbs pressure cold and that i needed a... oil filter/oil pressure issues ..read more

OK, I'm not really sure where to begin. I'm in the process of replacing the Lower Ball Joints in my 2002 4WD Sequoia Limited and came upon this ripped boot. I don't mind replacing this piece but I'm not sure if I need a longer CV axle because the Sequoia has been lifted or if I should buy original. I don't even know how to figure out how much lift I even have as I bought this thing already lifted. I am somewhat mechanically inclined but need the help... Help with CV Axle please ..read more

Anyone know the internal diameter of the hoses going to/from the trans cooler in a 1st gen ..read more

I put some 93 octane non ethanol gas in my 2001 Sequoia. After driving about 50 miles, I tried to crank and the engine, and it misfired & spit and sputtered. It would not stay running. In 262,000 miles, for the first time, it let me down. I was only 3 miles from home, and I called for a tow truck. Once at home, after replacing all 4 O2 sensors, fuel filter and pump (the old pump did test ok when removed), & MAF sensor, it still ran like crap. I had put about 4 gallons of the same gas back in... Knock sensor going bad ..read more

I know it won't lock if a door is open. I just replaced the rear hatch latch handle (AGAIN - why was this so terribly engineered?!) and I remember the mechanic had this problem last year when it was replaced. What's going on? If the hatch latches, which it does, and opens with the handle, which it does, why aren't the locks staying locked? I don't want my vehicle to stay unlocked at night, and I'd hate to have to disconnect the battery cable after locking (and before the automatic unlock) so... 2006 Sequoia, doors automatically unlock after locking ..read more

I have a 2013 Sequoia Limited without the airbag option. I recently installed the ReadyLIFT SST 3/2 inch spacer kit to raise and level the Sequoia. The spacer on the front is 3 inches, the rear is 2 inches. I then changed out the OEM shocks for 5100 Bilsteins I am now going through shocks like crazy on the rear end. Has anybody else had this issue with a similar lift. The ReadyLIFT system incorporates a shock extension to allow for the 2 inch lift in the rear. The extension brackets turn the... Suspension issues ..read more