Can I maybe get one of you guys to possibly send me a picture and show me exactly where I'm supposed to put the red tacky clutch Grease please and thank you sir ..read more

Finally listened on here and think it's time for a new clutch for my Huasheng 49cc. Ordered two, neither was correct. Eventually I'll find the correct one. But how the heck do I get the old clutch out? You Tube was no help at all. Thanks, Bill ..read more

I'm looking for a hub/sprocket adapter to fit a 1.25" (32mm) hub that can work with the standard 9 hole steel sprocket ..read more

The rear transmission gear looks like it has bent the square key. Does anyone know what size the key is? This is an ebay china doll kit not a grubee. I'm asking before I pull it off. I'm waiting till tomorrow to get my free bucket from HF to buy a pulley ..read more

Hello, yet another question. Huasheng 50cc.I took the clutch out, removing the belt. Belt is back on both pulleys but I don't know how to increase the tension. Trick? Special tool? Thanks, Bill ..read more

Ghost Racer 50cc. With engine at idle the rear wheel still turns, sometimes more than others. I'm brand new to the forum - any help is much appreciated! Thanks, Bill ..read more

Quick question,is there anyway to run a 44 tooth sprocket or higher when you have disc.brakes without having to do much modifications ..read more

Dear Fellow Motorheads, Have around 38km's on my 66cc motobike and am using a 4 bolt bracket ridgid tensioner that came with the Pk 80 kit (California Motorbikes). Bought another T-type tensioner, as that worked great on my 49cc until it was stolen. Also bought the sprocket drive cover spring loaded tensioner to possibly try out. Has anyone tried the ridgid half moon bracket that bolts to the bike frame and has just one idler wheel bolted to it? I realize that no tensioner works for... Read more ..read more

Hey guys what would be a good or better substitute for a drive chain without me having to change anything out ..read more

I'm running a 203mm disc brake rotor and would like to shred the rag joint by mounting to disc brakes. what all do i need? please list necessary bolts, nuts, washers, spacers etc because i truly do not know. aiming for 40t but I'll settle note: i won't use the rag joint because it's hard to true and i won't use a hub adapter because it slips ..read more