Mazda 2 2009 1.3 Control arm pinch bolt issue.
Mazdas 247 Forum » Mazda 2
by ockertyron
2d ago
Hello Everybody, just on the lookout for a bit of advice please. My lad has a 2009 Mazda 2. It is 1.3 ltr FWD DE DH 63KW 86HP JZ46. It failed it's MOT and the garage wanted £900 to replace a couple of tyres and both front control arms. It is a lot of money for an 18 year old (and me!) So I decided to have a go at it myself. The control arm bolts came off with a bit of elbow grease, but the pinch bolt is as stuck as anything I've ever worked on. It has obviously been worked on before... Read more ..read more
Visit website
2016 Mazda2 Driver Door Lock/Unlock Feature question
Mazdas 247 Forum » Mazda 2
by grotich
2d ago
I have a 2016 Mazda Demio (Mazda 2) and I have a question about the driver door lock/unlock function: On my dad's 2014 Toyota, when all the doors are locked and the Parking gear is engaged, the driver can open his/her door without unlocking all the doors. I find this feature useful and wanted to know if this can be done on my car through a setting or hardwiring. Thank you ..read more
Visit website
Driver Door Lock/Unlock Feature
Mazdas 247 Forum » Mazda 2
by grotich
1w ago
I have a 2016 Mazda Demio (Mazda 2) and I have a question about the driver door lock/unlock function: On my dad's 2014 Toyota, when all the doors are locked and the Parking gear is engaged, the driver can open his/her door without unlocking all the doors. I find this feature useful and wanted to know if this can be done on my car through a setting or hardwiring. Thank you ..read more
Visit website
Please help with my 2014 Mazda2
Mazdas 247 Forum » Mazda 2
by WeezieX
1w ago
So I sent in my wife’s 2014 Mazda 2 to the mechanic after it overheated and blew the head gasket. Radiator had a bad leak so it was replaced, head was resurfaced and a new head gasket was installed. After I got the car back, while driving it home, it began to sputter and it did not accelerate. It wasn’t like that when I took off but after I was about 10 miles down on the freeway. I noticed the traction control light came on and stayed on and the check engine light began to blink. After... Read more ..read more
Visit website
Mazda2 DE 2009 Japan Built - Fitting Full Size Spare 185 55 R15
Mazdas 247 Forum » Mazda 2
by OZCorolla_x
2w ago
The 2009 car came with a temporary space saver spare tyre. Not keen to use a "2009 temporary space saver spare tyre" that is limited to 80km/Hr & only permitted on rear of the car by an Insurance Policy Clause. The "Wheel Well Diameter" is too small for a 185 55 R15.....fully Deflated it almost pushes in if you "Silicon the Wheel Well". Have Others fitted a Full Size Spare 185 55 R15?.....What method did you use to enlarge the Wheel Well Diameter? Rob ..read more
Visit website
Mazda2 DE 1.5L OBD2 PIDs
Mazdas 247 Forum » Mazda 2
by OZCorolla_x
2w ago
JDIAG 906S Std OBD2 PIDs [1] DTC_CTN: [2] FUEL SYSA: [3] FUEL SYSB: [4] LOAD_PTC(%): [5] ECT (Deg C): [6] SHRTFT1(%): [7] LONGFT1(%): [8] MAP(kPa): [9] RPM: [10] VSS(km/H): [11] SPARKADV(Deg C): [12] IAT(Deg C): [13} MAF(g/s): [14] TP(%): [15] O2SLOC B1S12: [16] O2B1S2(V): [17] SHRTFTB1S2(%): [18] OBDSUP: [19] RunTM(SEC): [20] MIL_DIST(km): [21] EGR_PTC(%): [22] EVAP_PCT(%): [23] WARM_UPS: [24] CLR_DIST(km): [25] EQ_RATB1S1: [26] O2S11(mA): [27]... Read more ..read more
Visit website
Mazda2 DE 1.5L OBD2 PIDs Before and After Throttle Body Cleaning
Mazdas 247 Forum » Mazda 2
by OZCorolla_x
2w ago
Picked up a 2009 Mazda 2 1.5lt Doing all Fluids & General Maintenance so I get a Benchmark. Full Op Temp Idle TP was 12.2% =>> This is too High, Dirty Throttle Body, Dirty MAF & Dirty IAT ###################### MAZDA 2 Standard OBD2 PIDs: 2024_01_28: 171,065km ** BEFORE Throttle Body plus IAT & MAF Cleaning ** Before Cold Start: OBD2 Flyby Wire Throttle Body JDIAG 906S [1] DTC_CTN: 0 [2] FUEL SYSA: OL-Drive [3] FUEL SYSB: — [4] LOAD_PTC(%): 0.0 [5] ECT (Deg C): 29 [6]... Read more ..read more
Visit website
Lock / Unlock beep - Can it be added? 2015 Mazda2
Mazdas 247 Forum » Mazda 2
by larrens
2w ago
Hi I have a Mazda 2 DL (2015). There is no lock / unlock beep option in the menu. Has anyone tried adding a piezo speaker somewhere (e.g. central locking assembly) to enable to this feature? Thanks ..read more
Visit website
Lock / unlock beep - canb it be added
Mazdas 247 Forum » Mazda 2
by larrens
2w ago
Hi I have a Mazda 2 DL (2015). There is no lock / unlock beep option in the menu. Has anyone tried adding a piezo speaker somewhere (e.g. central locking assembly) to enable to this feature? Thanks ..read more
Visit website
Mazda2 2013 4door Automatic Transmission Gear Shift Knob Question/Problem
Mazdas 247 Forum » Mazda 2
by Dave@1234
2w ago
Recently the gear shift knob/gear shifter has come loose on my Mazda 2 Automatic Transmission. When shifted into a gear the whole assembly seems loose, twists and can move up/down more than it used to. Does anyone know how this assembly comes apart so I can diagnose the problem,.. or know how to tighten it back down? The gear shift knob has a button on the side that when pushed in,... allows you to change from park to drive, etc. and also has the overdrive on/off button below. Thanks ..read more
Visit website

Follow Mazdas 247 Forum » Mazda 2 on FeedSpot

Continue with Google
Continue with Apple
OR