Hey everyone! I just replaced the belt and tensioner pulley, but during an easy acceleration there is a squeal from up front. It’s not during start up/idle, it’s not during a hard acceleration. I can ride the squeal out and keep it making noise for 30 seconds, or if I put my foot down more it will stop squealing but the car will rev up harder than necessary. Any input would be awesome! I also just tried belt dressing and that didn’t help. Thanks ..read more

Embrace the freedom of casual encounters on the best dating app in town! Night butterflies: dating for special occasions True Females Optimal casual Dating ..read more

I replaced my oxygen sensor twice and I STILL get a P0051 & P1078 codes for my bank 2 sensor 1 02 censor. Can anyone suggest a possible solution. It's obviously NOT the 02 censor causing these codes as I have replaced with 2 new OEM sensors and get the same codes. Want to be accurate in matching wires. I was assuming this diagram referred to the (harness side) of the connector and not the connector side. but Im still getting trouble codes in my o2 censor ..read more

Hello, I was wondering if I could get a little help from some of you all.. My engine mounts are shot and I didn't find many DIY on YouTube except there is a fella that has a video to change out the front mount, but I really need to do the other 2 engine mounts as well and possibly the tranny mount, but I haven't inspected it yet.. Vehicle has 300k. How difficult are the other two engine mounts. Is there any videos or write ups I'm missing.. There's got to be more info about this somewhere. Shop quoted 10+ hours of labor for all 4 mounts. Thanks ..read more

'99 maxima GLE. Automatic temperature control. I've pulled the access panel on pass side of console to verify that the air mix door doesn't move when I cycle the temperature from 65* to 85*. The A/C seems to blow cold enough so I assume it's stuck on the cold side. All the modes work and so do the fan speeds, just no heat! Just want to make sure it really is the air mix door actuator before I spend $200 on a replacement and go through all the trouble (it's a PITA) of R&Ring it! Any thoughts ..read more

Its been a while since i been in this forum. Here we go again. I just bought a 16 maxima that was in a front collision. The car needs the two headlights replaced. It has the LED headlights and those expensive. Can I install the regular halogen headlights instead or is that a problem? Also where would i find a set of either headlights at a good price ..read more

Hi - Is there anyway these Black spots on the roof and tail can be cleaned? Or is it Rust and has to be repainted? Thanks in advance ..read more

So my power outlet doesn't work anymore, i checked the fuse its ok. what a Fing pain in the *** to get remove it and to search online. It seems this part doesn't exist!? haha i bought online but its not the right one. Can someone help me, i dont understand why its so difficult to find a replacement. the picture is the OEM part 2017 max sl ..read more

How often do you guys change your oil? Went to the dealer and asked what kind of oil they used, they said it was a synthetic blend $59, and said it's changed every 3,000 miles. Full synthetic was $140. I believe the manual states for 2023's to use NISSAN Motor Oil 0W-20 SP and change every 7,500 miles or 6 months ..read more

I am not sure what to call this but has anyone experienced this paint issue? Any solutions? I’m pretty sure Nissan wouldn’t cover this so any thoughts on this would be appreciated. Thanks ..read more