This unit will come with a 3pt blade and a johnny bucket. And a serious need for new shoes. One of the plans is to get a sickle bar for it. Much needed for edge-of-pond trimming and ditch weeds... First foray into a different brand unit, as past experience revolved around ht-20 Bolens. This will be a nice add. I think/hope ..read more

I have '08? Gehl skidsteer that had a 3TNV88 engine. It was removed and lost before I bought it. I recently found a 2018 3TNV88C powerplant engine. It is a perfect fit excep it was wired to monitor everything, emissions, when to start/when to stop, ect. it is set up to meet Cal emissions. The injectors appear to be electrical controlled, as well as there is sensor on the front of the timing chain cover (like a cam sensor.) most of the rest of the wiring I think I can figure out. But Im... 2018 yanmar 3TNV88C power plant ..read more

My YM1510D Yanmar old tractor has had a broken steering gear twice in 10 years. The first time, the bearings disintegrated and the second time recently, the steering knuckle split in half so that all the little ball bearings fell out and the steering wheel simply spins around with no effect on the front wheels. I'm fairly sure this tractor was not designed for the aftermarket frontloader that was installed before I purchased it. I am looking for a new steering shaft with the steering knuckle... Yanmar YM1510D has a fractured steering knuckle ..read more

Came across this at auction and won! Seems to run decent. Can't wait to get it home and see if the attachments all work. I'm thinking I'll be spending a lot of time in this forum ..read more

I have a Yanmar YM2000 whose only attachment is the rear lift. I have had the tractor for about 10 years and only put 20 hours on it. This spring I started it to help yank a downed tree out. The hydraulic lift did not work at all. I have been trying to find a local tech. I was told that I probably needed to change the hydraulic oil and filter. This past weekend I did that. Put in 16 quarts of oil and a new filter. Started it up. hydraulic does not move. What have I missed ..read more

Looking for a yanmar parts manual or someone that has a copy that can look up the steering sector shaft on a F215 ..read more

I am going to look at 135D that was owned since new by a late cousin . It runs and was well maintained through out the years. I know its old but I don't know much about the brand or the value. I understand they are/were pretty reliable little tractors but the age does concern me. Couple of questions. Any idea of the value? it will be part of an estate auction. Parts?? Is there much parts support for these old machines ? Any input will be appreciated. Thanks Tom ..read more

I know that eventually I will need something bigger and stronger than my CRAFTSMAN GT II w/ loader, After doing extensive research on Deere tractors that utilize Yanmar engine - I started shopping yanmar. I found one a short 30 minutes away asking $5500 with the YFL155 FEL, includes ballast box, block heater. 1300 hours. Does this sound about reasonable? Cross-posted @... Anything I should know about the YM155D ..read more

I have been searching for a front drive shaft for my 1984 JD 650 MFWD for months with no luck. The research I have done shows that the Yanmar and John Deere CUT of the 1980's were very similar. In pure desperation, I am hoping that maybe someone could tell me if the Yanmar tractor has the same or similar drive shaft. Most importantly the 15 spline x 11/16" diameter yoke end. Thanks for any information you can provide ..read more

Does anyone know the correct name for the rear case that controls the pto hydraulic lift arms? I have a 155D yanmar ..read more