Needing FX4 transfer case shifter ****. Last piece I need to complete my twin stick conversion ..read more

Hello all! I'm replacing my PCV in my 2.5 and notice the grommet is in poor shape. Seems to be a hard part to find and I'm having no luck. Anyone else dealing with this and find a fix? Any help would be greatly appreciated ..read more

I have an 07 ranger with the 4 litre. About a week ago while driving I noticed my battery light was flickering. About the same time I noticed it, my radio and all gauges died out on me. Made it home and charged my battery up. The battery light stayed on. Assuming it was the alternator I replaced it. After that the battery light turned off and I thought I had solved the problem. Later that night I was sitting in my truck listening to music with the truck idling and the same thing happened, radio died out and then all gauges drop off and the engine itself almost died. Yesterday I bought a new ba ..read more

hi all! horn on my 84 does not work—took the dash and instrument panel off to try and trace the circuit, thinking it was a short, but it appears the horn wires are just, not plugged in? see photo below my wiring diagram says the yellow/light blue dot cable and the dark blue cable run the horn circuit, but i can’t find any place where that plug there should be inserted, nor can i see via the wiring diagram where it’s supposed to go (or what connector number that is…) diagram below. checked the connectors on the steering column and didn’t see any place to plug it, and besides the amount o ..read more

2011 Ranger 4x4 4-door Sport, 4L 6-banger AT. I have 2 fobs. When I program the second fob into the RKE system, the 1st fob quits working. Do I have to go to the stealership to clear the programming? I program the first fob into the RKE chip (On-Off 8 times - leaving it in on with the 8th sequence - locks cycle). I program the fob, and the locks cycle. I turn off the truck, and the fob works flawlessly. I rinse-repeat with the second fob. Second fob works flawlessly, but the first fob quits working. What gives - I'm pulling my hair out, and can't find any reference to this in any thread, eith ..read more

91 ranger, xlt. 2.9L- Shift motor is good but is not receiving power. All fuses good, all relays good.Have tried 3 different modules, when go to do self test, the light never flashes or turns on all of them. Replaced shift motor with new one and still nothing. Replaced 4x4 switch and did nothing. Manual hubs are switched on. 2 shops have looked at it and can not figure out the issue. Both said shift motor is not receiving power. I possibly think it may be a grounding issue but don’t know how to add ground to it. Is this a grounding issue? Or a broken wire somewhere? Why does the module sudde ..read more

To keep this short. I am replacing the fender rails on my 1999 Ford Ranger as the person before me cut them to get the radiator support. I was wondering if their was any 3rd party fender rail replacement ..read more

1998 Ford Ranger, 302 5.0L 5-Speed On Ebay https://www.ebay.com/itm/335394441567 ..read more

Can someone tell me what size front brake rotors i have? It is a 2001 xlt 4.0 2wd thanks ..read more

What are these little boxes (photo attached)? The black cylinder on the upper left is a Rostra cruise control installed a few years ago. The arrowed wire on the right little box gets current from the starter relay on the right. Photo taken with a 20-year old digital camera,Konica Minolta Z10 ..read more