Her ..read more

Hey everyone! I decided to paint the center bezel and around the shifter black and I painted it in a hammered finish, which I think came out really good. I will post pictures soon! Anyways, I want to do some pieces on the door as well. I’m going to paint the ring around the speaker which I know how to remove, but I also want to paint the piece where the window switches and the mirror controls are located. I guess this is the "armrest" area. However, I can’t figure out how to take off that... Window Switches Trim ..read more

My old washer nozzle tip gave out, squirtting washer fluid out like a garden hose without a spray nozzle. While switching to a new one, a thought came to mind to try paint the nozzle. Not the best paint job, but it turned out better than expected. Still sticks out, but not as much as two black dots that were there ..read more

I have tried twice to press this bushing in the (forward control arm, forward position). Failed each time getting the bushing about 80% in. I used the bolt and nut assembly to get that far no problem, but it halted at that point, each time. I also tried after that to continue with a home made press getting to about 700 lbs of pressure without success. It seems like that should be enough pressure. Then I took the arm as shown to a local front end shop which gave it a try. They came back... Problem pressing control arm bushing (2010 Caliber ..read more

my 2009 has code po300, random misfire, engine light blinking. I replaced the plugs and the ignition coils, no change. 2 plugs looked black. this all started after cleaning the throttle body, the lightening bolt light was oing on and off once in a while. car seems to run just fine. what to check next ..read more

So my ex-boyfriend gave me a 2009 dodge caliber and he drove it to my house but since then it hasn’t started it was throwing the red lightning bolt code thing saying the electronic throttle body and so I changed that but now I feel like it’s even worse than it was before And I tried to look at all the wires to see if anybody connections. There were all the fuses all relays to crank, but it won’t start and sometimes it would like drowned out while cranking. I have no idea maybe somebody else... Electronic throttlebody or wiring I have no idea which one ..read more

I have been getting a OBD po264 code cylinder 2 circuit low, I have changed the fuel injector, the computer, the starter relays and have not found a bad wire. Has anyone else had this problem and have an idea on what is wrong ..read more

abs pump will not stop running even with car turned off anybody have any idea why ..read more

I have 2010 dodge caliber and am experiencing the sputter Happens sometimes when I accelerate. If I drive under 50 sometimes it won't sputter. Hope you have maybe an idea. Thanks so much ..read more

Hello. I have a caliber 2010 which is now sputtering when accelerating. Any one experience this issue ..read more