Hello everyone! i have exhausted all avenues to find out what is happening with my ride. Need your expert help. While driving or warming up the car. Engine running or engine off. The wipers start by itself and wont turn off. I get all sorts of warning lights on the dash as if it’s the end of the world. I did go online and started reading everything that resembled what i was experiencing scanned it with the Autel 808 cleared it. Next day check engine plus all the warnings with the wipers on. Scanned and got U118A then scanned it again and got a bunch full of codes. On the freeway the gong so ..read more

HELLO GUYS , The car stood for 6 month , came to the shop , replaced the battery . and I have this and Restiner system error on . I cheked the fused and all 4 fuses was ok . bcm needed to be replace ..read more

Hey yall. Im having the hardest time trying to fine the header collector Gasket for my 2002 X5 4.4 m62tu. It looks like a lead o ring type crush gasket thet connects the header to mid pipes. I went to REAL OEM and i do not see that o ring gasket. Need help. Thank you Attached Images IMG_8042.jpeg (360.9 KB ..read more

Can the 2004 radio/head unit with DPS/Nav be replaced with one from a 2005 ..read more

2010 35d but it appears to happen to lots of other BMWs. I changed the oil level sensor and now when I check oil level in idrive it says “measurement inactive”. I don’t get any errors when I run ISTA ..read more

Hello Everyone. I am having a Chassis warning on my I-Drive after driving for a couple of miles and upon checking on my OBD reader these codes appear 480DB1 and 480DB5. I am wondering if this is the ride height sensor? Does it need to be changed right away? What are the other checks that needs to be done before replacing this part? If so, can I have the part number of this spare part? Thank you in advance everyone. https://i.im.ge/2024/05/06/ZRUn8z.92...6B3A4-new.jpeg https://i.im.ge/2024/05/06/ZRUBQ6.Sc...622509962.jpeg ..read more

I will sometime be sitting down with the key in my pocket and it will open the car hatch which makes it crash into the garage door. I have a 2018 X5. What can I do? Thanks in advance ..read more

I'm running into what I think to be a fairly known issue with a gasket getting sucked into the throttle body. 2003, 3.0 (gas, not diesel) The diagram shows the gasket to go between part 1, and 4, but I can't (for the life of me) get it even close to fitting. That being said, the part where the hose clamp sits on part 4 (for this union) seems to be molded / fused to the rest of the tube, and is of a softer plastic / rubber that can form to the male side of part #1. Do I forgo this gasket (part #3), or do I find a way to stretch out the mating surface of #4 so the gasket can fit (and ultimate ..read more

I've owned older Japanese cars and am pretty comfortable working around engines, but I'm a bit stumped with my X5. I parked my X5 for a two weeks and noticed some issues when I was trying to start it on the weekend and I could hear the engine trying to start. I have CA, so the it kept trying to start while I held down the break. Originally, I thought it was a dead battery so I charged it, and no change. I've gone ahead an replaced the battery, since it's been in the truck since it was purchased. I ran a quick check using ISTA+ and I'm getting the following codes: 0032AB EWS-DME message i ..read more

Morning all, I had an issue with my ABS (turns out it wasn'tthe ABS it was a bad wire), so changed the pump now I'm trying to bleed the brakes with not much luck. I have tried gravity bleeding Pressure bleeding And using my diagnostic to activate the pump When the car is off and I pump the brake, about half way down, there is like a step is probably the best way to describe it. There is resistance both sides of the "step" Nothing seems to give me a firm pedal when the car is running Just to add, the brakes were working absolutely fine before I changed the pump. I have no leaks anywhere. I ..read more