Greetings! I hope everyone is doing well. I am looking for the name of this electronic component if someone knew please reply and tell. It is located on the cold side part of the PCB inside my E-bike charger. Thank you in advanced ..read more

i have this remote control - sw0 and sw1 are buttons but i want to run wires out of the pcb to a foot pedal to simulate button press. any experts out there can look at this and determine where i should solder wires for sw0 and sw1? is it possible to determine from looking at these photos? tIA ..read more

My company recently acquired the Vitrox-V510 Optical Inspection Station, equipped with the 'V510 Series' software. However, I've noticed that the software appears to be outdated and doesn't meet modern standards. It lacks a comprehensive component library and has limited functionality. While I'm currently studying the user manual to gain a better understanding of the system, I'm reaching out here for assistance. If anyone has experience using this machine, I would greatly appreciate... Read more ..read more

Hi everyone, wanted to kindly ask if you know where I can buy these kind of connectors and the Male version that plug into these please. Thanks ..read more

Hi I'm trying to design a circuit that switches between a manual button push to activate a relay and an Arduino output to activate the relay. I can get the switching and relay working fine however I want to add two LEDs to indicate which output is currently selected. I need an LED to light up constantly if the switch is on the Arduino but not to trigger the relay unless there's an output from the Arduino. The circuit below just lights everything up regardless of which side the switch is on... Read more ..read more

hey i want to know if there's a way to open a gerber file in altium thatb design in another software(easyeda) and if so' how? and after i open the gerber file i could change things in it? and contvert the garber to schematic ..read more

Hey all this would be my first try at creating a schematic in KiCad. The schematic is a basic 2-channel relay. The inputs are automotive 12v and gnd. This gets converted to 5v by the K78L05-1000R3. The Wemos D1 mini has 2 digital pin outs that are 3.3v going to the LTV-356T with a 200 kOhms resistor in between. From there it goes to a 1k resistor and then to the PMBT3904. Between that and the G5LE-1 relay is a 1N4007F. In that same... Read more ..read more

Hey Guys, I need to add component BP2831A Non-isolated Buck Offline LED Driver to Proteus 8. Can someone help me to find the component library please? It was not available in SnapEDA and also, SnapEDA doesnot have an option to download as Proteus compatible file. Your help is much appreciated. I have given the link to the specific datasheet if you are interested to see. Datasheet Link Thanks ..read more

I don't know what's wrong with this circuit. I get an error when I click the button after pressing the button ..read more

How do I move a silkscreen component from the bottom silkscreen to the top silkscreen in Easy EDA ..read more