My son bought this tractor and he is no longer with me...... I'm moving and I have to sell it. I can see yellow paint under the red. I have searched for the serial number for hours, cannot find a match? Can someone help me identify it and tell me what it's worth please? The nameplate says corps of engineers U.S. Army..? Any help is very much appreciated, thank you [ATTACH... International harvester tractor ..read more

What is this ..read more

Found this in a old milk barn , something for livestock? some kind of retainer for heavy loads?. With that many attach holes must secure a heavy load? Interesting engineering that attach points are about 45 degree load bearing , thanks ..read more

Looking for information on Oliver outboards before 1960. Thanks ..read more

I have what I believe to be an early 70s model Atlas tiller. On the plate it says it's a model T200. Curious if anyone has any additional information regarding them because I've tried researching and can't find any information what so ever. Thanks ..read more

Good morning, my dad is trying to restore a vintage model L manure spreader and we need the axle and the right side bearing housing that the axle goes through. Any help out there ..read more

Recently acquired a Deere Model K Series 47 Manure Spreader with rubber tires. Looking for a few parts... An intact seat spring - Part number J16271C. Also missing the the right rear chain guard with hand hole - Part number J15697C. Need all evener assemblies as well. Anyone have suggestions for sources ..read more

Check this out! [ame]https://www.youtube.com/watch?v=ld_LUfxrfEw[/ame ..read more

A while back I picked up this old garden tractor. The guy I bought it from said he thought it was a ford. A friend said it looked like a Gibson and others said it was a sears surburban. This tractor has a 10 HP Briggs&Straton engine. I had it running but the carb is shot. I really need to ID this so I can get back on it and see if I can fix it up. Tractor has a drive shaft and is coupled by belts to the engine. The rear end is hydrostatic and makes me believe the tractor is not as old... Help identify this lawn tractor ..read more

I have a 10 HP k241as Kohler that misses at higher rmp in 3rd gear. By higher rpm I mean less than 3200. I couldn't get it to start when I got it. I replaced the vavles lapped in and checked proper clearance. Carb was taken off and cleaned. Governor was reset to spec. Plug replaced with champion. Head gasket replaced tank cleaned and screen. No fuel leaks. It does run good in other gears but sometime misses under load. Any ideas? Also is their a newer style engine that fits this cub. Thanks... Cub cadet 102 ..read more