Parker Community » Hydraulics
5 FOLLOWERS
Welcome to the Parker support community, Parker hydraulics forum enables and improves machinery performance. Browse a forum to ask related questions and expand the hydraulics knowledge base.
Parker Community » Hydraulics
3M ago
Hello,
I have a customer looking for some information on a valve he has on a 1994 Iowa DOT truck. All I have to go off of is some photos he sent over. Any info would be greatly appreciated. Thank you ..read more
Parker Community » Hydraulics
1y ago
Hello,
The HP2 Series is composed of two independently controlled over-center, piston pumps on a single drive shaft. They are housed in a compact reservoir with a filter and associated valving. Speed range 1800 to 3600 rpm. Intermittent pressure 2600 psi.
Check Out Another Article regarding Dask Cam - what is wdr on dash cam ..read more
Parker Community » Hydraulics
1y ago
Really?
Then your are not following VFO as Variable Flow Opencenter hydraulics
Other definitions on the acronym VFO
Acronym Definition
VFO Variable-Frequency Oscillator
VFO Variable Frequency Oscillator
VFO Vrb Fan Out
VFO Vernal Field Office (US DOI; Utah)
VFO Virtual Front Office (Telcordia)
VFO Violent Felony Offense
VFO Vital Few Objectives (strategic planning)
VFO Variable Fuel Oil Tank ..read more
Parker Community » Hydraulics
1y ago
Item
Description
Action
Check fluid level in reservoir.
Insufficient hydraulic fluid causes cavitation.
Fill the reservoir to proper level.
Check for air in system.
Air in system causes noisy, erratic control.
Purge air and tighten fittings. Check inlet for leaks.
Check pump inlet pressure/vacuum.
Improper inlet conditions cause erratic behavior and low output flow.
Correct pump inlet pressure / vacuum conditions. Refer to the Hydraulic Parameters topic.
Inspect shaft couplings.
A loose or incorrect shaft coupling causes excessive noise and/or vibration.
Repair or replace ..read more
Parker Community » Hydraulics
1y ago
Thank you for reaching out. We recommend that you find a Hydraulics Technology Center in your area to help you troubleshoot the system issue. You can search our network here to find support: Home - Where To Buy (parker.com ..read more
Parker Community » Hydraulics
1y ago
Good afternoon. I am fitting a Hiab 115 crane to a truck and am not getting any pressure. Pump is good and solenoid dump valve is permanently closed. No leaks observed. Crane is in good condition but has been standing some time. Valve block is Olsbergs type 91 (3957021)
Out riggers, fed direct from block, move very very slowly down and will now not return.
Can somebody please advise what may be the problem ..read more
Parker Community » Hydraulics
1y ago
Hey guys and ladies. Having trouble with our steering system on our crane. I can turn the wheels about 10 degrees each way on one of our cranes but then the sterling goes stiff to where no amount of force can turn them anymore. i know there not siezed as when it’s on its legs with the wheels of the floor they turn really easy with one finger. The steering orbital valve makes a loud squeal when trying to turn solid and sometimes makes a whining sound even when not turning and hands of wheel. I have tried turning the wheel back and forth where it is easy and flicked a switch to send power to the ..read more
Parker Community » Hydraulics
1y ago
Hydraulic components or device with sensors and two-way communication interfaces can communicate all other components or devices and main computer with the help of software. In most hydraulic components, the hydraulic fluid provides internal lubrication. Pump elements and other wear parts slide against each other on a film of fluid.
For more hydraulic components visit: Filtersmart Reviews ..read more
Parker Community » Hydraulics
1y ago
Hey,
I am really happy after reading your post on hydraulic actuator response which gave me so much information about that ..read more