@Chief bonehead ... I know this is probably outside of your dept, but does the 'motorboard' on the new Flexus subwoofer act as a lens of some kind, for phase or directionality, even though the frequencies are omni-directional, or are they merely esthetic?   ..read more

I have a 115sw sub, I want to add another one but they are hard to find , does the 115sw work well with the  new spl150? are they  compatible ?  ..read more

Tried searching but got no hits-   Need a sub and was wondering what you might suggest?  Current setup is Cambridge Audio AXR100, main source is Wiim Pro Streamer.     ..read more

I just purchased a RP-1200sw on Monday and the power indicator light only worked for a hour, now it does not come on but the subwoofer does have power also the gain has to be turned to 7 for any significant bass to be heard. Has anyone had this issue before ..read more

Good evening everyone,   I was just wondering what I should have my settings on the rear of my sub set to?    I own is 2 x Klipsch Synergy F3's and the Klipsch 12" subwoofer. http://www.klipsch.com.au/products/f-3-floorstanding-speaker & http://www.klipsch.com.au/products/sub-12-subwoofer   I'm just not sure what to set the marked settings to?   I will have my sub connected to my receiver (Yamaha RX-A860 or Yamaha RX-A1060, yet to arrive) via the red RCA input.   Thank you for your advice.   Steve ..read more

Hoping I can get some fresh info.  I spent lots of time on the forum MANY years ago with my Klipsch Chorus II's and Academy setup but when kids came along, we didn't use the surround system so I stopped running it.  I also have a Sub 12 that's been sitting over in the corner for years possibly plugged in and powered on with no signal ever sent to it(my fault for not turning it off).  Long story short, my family has finally asked me to get the home theater up and running (kids are older now).  I used the YPAO to calibrate my system with the Yamaha V675 receiver and the sub g ..read more

My RSW-12 seems to have finally gave out or at least it seems the power supply has.  It did not blow the fuse but when I enable power the front LED flashes red and then goes out.  Sometimes I hear a bit of noise from the speaker and sometimes not.  I am guess the electrolytics have given out in the power supply.  I am wondering if someone has a service manual for this unit and any suggestions on what board might be the culprit.  I did see in previous posts that one or two members had the service manual but I am too new to be able to message them yet.  Any help or ..read more

After one week i absolutely love this sub and i wouldn't change it for anything.  There's only one little thing i recognised. Everytime the sub switches itself off, i hear a silent "plop" sound. Very quiet, but recognisable. Is that normal with that sub or is there a problem with the one i got ..read more

If you get a chance to fire up this game, watch your subs flex. They definitely didn't design it for TV speakers. Tons of stuff that is probably single digit frequencies along with everything else. Serious flexing at super low frequencies for a game ..read more

my SPL-150 15 amp blew in Nov I contacted support ,said they would send replacement in about first said 2 weeks then said March still heard nothing. is it normal to be waiting since November 2023 for warranty replacement part ..read more