Ruger Pistol Forums » Ruger MK IV
2 FOLLOWERS
The Ruger Pistol Forums is a place that has chat rooms for Ruger pistol firearm owners to chat about Ruger MK IV, and other firearms, talk bout ammo cache, and firearm laws find rug recommendations and discuss shooting problems.
Ruger Pistol Forums » Ruger MK IV
2M ago
Hello.
I am a new owner of a Mark IV ( is it OK to say MK4? ) tactical. Williams sights on order. Will defiantly need trigger work. Came with an extra VSQ 6" upper and VSQ bolt.
Suggestions/help for a smooth non creepy trigger wanted. Thanks ..read more
Ruger Pistol Forums » Ruger MK IV
5M ago
Whats the consensus on short barrels,how short can you go with supressor and keep reliability and accuracy ..read more
Ruger Pistol Forums » Ruger MK IV
6M ago
Checking to see if my Mark IV 22/45 Lite without a threaded barrel can be converted to threaded? I have a 22 cal suppressor in ATF jail at the LGS awaiting its release.
I can check with my local gunsmith or see if this is something that Ruger can do if I send it in.
Thanks in advance ..read more
Ruger Pistol Forums » Ruger MK IV
8M ago
Mag insertion is not consistent. I am left handed. Not my fault . To fully insert mag, with pistol in my left hand, sometimes I have to press mag away from me to fully insert mag. I have 6 Ruger mags approved for Hunter. Mag insertion is inconsistent in 4 mags and nearly impossible in 2 mags.
Is there a problem with the part 11 mag latch?
Any thoughts are welcome.
The age old question - Is it the shooter or the gun?
Thank you ..read more
Ruger Pistol Forums » Ruger MK IV
8M ago
Just added a little bling to my already badass new .22lr. These look great and fit perfectly ..read more
Ruger Pistol Forums » Ruger MK IV
8M ago
Is this a common problem? I'm trying thread locker ..read more
Ruger Pistol Forums » Ruger MK IV
1y ago
Hi, I just purchased my first Ruger Mark 4 Target pistol. I have read through the instruction manual (many times), but I am still having problems moving the safety from “off” to “fire” position. I went through the step by step procedures with no luck. I sure would appreciate any help with this issue. I am feeling kind of dumb? Any help would be great!
Thank you from the fellow that wants to get to the Range ..read more
Ruger Pistol Forums » Ruger MK IV
1y ago
I installed a Volquartsen trigger set in my Mark IV. My pull went down to 1 LB 11.6 oz. I would like it to be a little heavier, what can I do to raise it a little, it's a little to touchy for me ..read more
Ruger Pistol Forums » Ruger MK IV
1y ago
I have a MK IV 22/45. I upgraded the extractor to the Volquartzen, and noticed that the bottom edge (pic shows the extractor upside down) appears to have worn down. Anyone else see this behavior?
It bears notice that I have had some failure to extract issues, especially with standard velocity. I just installed a Tandemcross extractor, and will see if I get the same behavior. (The stock stamped piece did not appear to have this issue.)
I ..read more
Ruger Pistol Forums » Ruger MK IV
1y ago
I was cleaning my Ruger MarkIV Hunter and forgot to put bolt back into bolt receiver, then I closed bolt receiver, now I can’t open bolt receiver to install bolt. I pushed on take down button but nothing happens ..read more