I just added a 5x5 tent to my grow setup, I plan to use it to house mother plants permanently and grow clones before they move to the 4x8 tent for veg and flower. What would be a good light for the 5x5 for my intended use ..read more

My inkbird temp controler showed up today. Thank you @INKBIRD for doing this giveaway ..read more

This closet is 6 feet tall and I'm growing one plant under a 2x2 sf1000. I'm assuming if I completely cover all the walls with reflective material except the opening, I will still have enough light on the plant ..read more

So I have two thirteen by thirteen rooms that I plan on doing an 8 light grow in my basement. Four lights in each room. I'm using gavitas lights and just running two lights at 100% the rooms have gotten up to 80 degrees. I have a fairly large basement but let's just say the basement is 26x26. Right now I have two 12 inch inline fans but only one is hooked up. I have the room on the left side dumping to the right side but I'm not sure if I wanna construct an exhaust in the right side room to... Read more ..read more

Hey all : ) I am needing some advice for lung room and grow space setup (there’s a lot to unpack here)I read through the all the posts on this subject here on the farm and couldnt quite get my specific situation figured out based off of those threads. my current setup is as fallows : Now mind you I have not run the AC in the way of controlling temp (just put it there because it seemed like a good idea). I use the inlet to get cool air into the room from ducting that goes to the... Read more ..read more

Hey growmies I’m starting a 4x8 tent my question is do I absolutely need a separate space to dry if strains that I’m growing finish 8-9 weeks alike ..read more

Hey guys I’m gonna be staring my first grow 4x8 8 5 gallon pots, being that I’m new my main concern has been watering as I’ve read it’s easy to over/under water easily, so I was looking in to the ac infinity self watering pots, auto pots or drip irrigation, what do you guys think is the easiest most sufficient way to go ..read more

In most of the agricultural and HVAC world they use the unit W/m^2 for the lightpower in most of the design calculation. But these numbers are never given for LED growlights. There are some empirical equations to convert from Umols/s/m^2 to Wm but those can be quite off since the lightpower is dependant on the spectrum of the light. And spectrums of different growlight are almost never identical. And you cant base your calculation on the power rating of the growlight since it doesn't only... Read more ..read more

Anyone have and currently using a Trolmaster 3-in-1 Water Content Sensor（WCS-2). Where is the best placement for the sensor? Is it on top of the coco grow media or along the side of the grow media through the grow container somewhere in the middle ..read more

Morning all, I’m going nuts trying to control temperature AND humidity during warmer months. In cold weather, no problem. This is for flower only. Set up: 8x8 tent. One 4x4 space has 4 pot RDWC setup, one 4x4 space I’m using four 7.5 gallon smart pots. Each of these areas have 630 watt led lights. The remaining 4x8 area is used for equipment. The tent is in a barn without heat or air. I have an 8” inline exhaust fan, two passive six inch ducts vent air directly on my lights when the... Read more ..read more