I am interested in making repairs to my machine, I have the dealer manuals but they lack data on the Hydrostatic pumps... I do not want to pull the pump out until I have information on it and be able to ID it.... I believe it is Eaton but I cannot see any numbers to see group or type and figuration... Does anyone know of someone who can assist me on how to 1. Id pump manufacturer. 2. locate a manual for the pump, This unit is a lx865 1999...... Any help would be greatly appreciated... Thanks ..read more

I have a 2008 New Holland L190 that died on me and won't start. It turns over but won't even pop. I cracked one of the injector lines and I don't get anything. Plenty of fuel and the fuel is fresh. It's 16 degrees out. All of the fuses are good. This model has a mechanical fuel pump. Any help is greatly appreciated ..read more

The starter is bad and I need the boom up. What do I need to disconnect to bleed off pressure when using the forklift to raise it up? Also, what do the items in the attached photo do? I'd appreciate any help ..read more

I have a New Holland LX865. I recently bought a GPS tracking device for it but as I read the installation instructions, it says that the tracker cannot be surrounded by metal. Thats a tall order in a machine that is 90% metal. I called their tech support and the kid I spoke to didnt seem to know what he was talking about. Any input on device placement would be appreciated ..read more

I have an early 90's model L785 skid steer. I haven't had it long and we are into cold weather. I am trying to get the intake heater to work. I have confirmed that I have battery to the heater and can see it glow. There is a fuel line that goes from the fuel pump to that heater, as well. The best that I can tell, is that there is no fuel getting to the heater plug. I have taken the line off and the pump and there is a little bit coming out, but none to the top of the line. I did make sure... Read more ..read more

Mice chewed through the wires on my boom/bucket solenoids. I replaced the solenoids but still have the code. One issue might be the wiring, the plugin on the new ones didn't match the old ones, so I cut and spliced the old connectors unto the new solenoids. There were no markings to differentiate the wires, so I assumed it didn't matter which went to which. I unhooked the battery for ten minutes hoping that would clear the codes but didn't ..read more

I have a New Holland ls190 that doesn't get used as much as it used to, so the batteries go dead. Which battery maintainer would be appropriate for this application? Thanks in advance ..read more

Gents, I just picked up a NH L553 with the V1902 Kubota engine. I'm looking around for pdf of the service, operators, and parts manuals for this machine. I'd prefer to find free versions if they are out there. So far, all I have found is paid versions. Any ideas? Thanks ..read more

have a new holland L783 with a perkins 4.203 (just rebuilt) having a issue with the injection pump throttle linkage looking for a clear picture of the proper routing of the linkage and spring location, currently haven't been able to get the engine started. not getting much fuel to the injector thanks for any info or help ..read more

I picked up an old New Holland L35 Skid. I had to fix the stuck engine. I used pb blaster to free up the engine. I did get it to run to find the right side drive is dead. All the other stuff functions. The gears under the cover are slipping on trying to move the right side. This machine tries to stall if you try to go forward or reverse on the right. I jacked up the right side off of the ground and it still stalls. I don't think the gears are stuck together. Anyone have ideas? PS the... Read more ..read more