I’m looking for somewhere within reasonable driving distance to have some custom pistol frame work done. I’m looking at getting a dual undercut put on a Glock 19. I’m around the Ft Wayne area. I’d like not to mess with shipping is the reason I ask. Thanks all ..read more

While cleaning my 1911, noticed the link pin sitting on the table. First thought was, WTF is that, then how the hell did that happen? It had just fallen out. Was cleaning another one next to it by the same manufacture and it seemed nice and tight. The broken one has just over 500 rounds through it so it's still covered under warranty but I just hope I can just send the barrel back to get it fixed. Any thoughts to why it should happen ..read more

Good day everyone, like the title says I'm in search of a good shop that can thread the fluted barrel on my MK IV Hunter if anyone has had it done and was pleased with the work ..read more

My pps m2 trigger is feeling pretty heavy. When shooting over the weekend, if i slowly squeezed the trigger, it felt really hard and you couldn't feel it break at all. If i squeezed trigger faster, it still was heavy but not as hard. I want to disassemble and polish up the trigger assembly like i did on a marlin 60 years back. It shoots great but it doesn't come close to the trigger on my px4 storm or sr1911. I have the skill to do the work, but taking apart is a bit foreign being the... Read more ..read more

Looking at having holes for a no longer existing scope mount on an 81 Remington filled. I've seen the suggestion of loctiting screw into the holes, grind the heads off and peen the remainder to blend it into the receiver. Many mention tig, but I can't find an example of where it's been done (and reblued). Has anyone done or had this done before? If the TIG route, I'd send it out to someone experienced. Obviously it would be reblued afterwards ..read more

..read more

Anyone in central Indiana that does hydro dip? I’m looking to have a few items done in Realtree Edge or a similar knock off. Having a very hard time finding someone ..read more

Have any of you built your own tool that will safely depress the ejector so that the tension is off of the roll pin? Does to the ejector pin need to be depressed further than the bolt face or is flush with the bolt face far enough? Midway and Brownells are backordered on the fixtures, but any leads on a good tool would also be helpful. Thanks ..read more

Looking for a quality gun vise that can both hold my long guns solidly for scope mounting and repairs on my guns, as well as general cleaning maintenance....Much appreciated ..read more

Looking to get both of my 6.5 barrels threaded. Does anyone on here know anyone that does it local in Fort Wayne ..read more