Gentlemen I'm looking for someone who owns a lathe or a mill and be willing to do a small job for me. I am wanting to pillar bed my stock and the pillars need to be cut/ squared to size. They are brass tubes 3/8" OD. I can send them snail mail if needed. PM if interested Thank you ..read more

I've got a compact 1911 that's doing something funny. Completely assembled, slowly closing the slide, it sort of "sticks" a little bit when it's about 1/8" from being completely in battery. I haven't ever had a problem with it, but somebody else was shooting it, probably limp-wristing it, and it wouldn't go fully back into battery - tap the slide, and it was good to go. That just kind of bothered me. I started messing around with it - pulled the recoil spring out and felt the same... Read more ..read more

I may have a loose screw or two… but I cannot get this trigger adjustment screw loose (to adjust) on my Savage Stevens model 334 .308 bolt action. It’s factory glued (or something) in place any ideas? I’ve been trying heat and acetone, and other chemicals that may break it free from the epoxy (or whatever) they used at the factory I have very good screwdrivers that fit (even hollow ground types) but the head won‘t last forever here’s a picture (not me) of the screw I’m working on …. And... Read more ..read more

Here's a quick inside view to show off our techniques to precision CNC machine our AR15 Gas Blocks, designed for optimal performance and weight reduction. Machined in Rockledge, Florida by our experienced machinists. Check out our gas block here ..read more

Anyone know of any gunsmiths in the Houston area that can chamber and thread a barrel blank? Mainly curious to see if there is a place local if ever needed ..read more

Let one of the boys assist in lapping an upper before I bed the barrel ..read more

I have a 6.5 Grendel AR barrel that has an un-even throat. I did a cerrosafe cast of the chamber, and 2 or 3 of the lands seem to stop about 1/8" in front of the chamber neck, and a couple of the lands come back almost to the end of the neck. I can chamber loads that have the bullets seated back into the case a little farther than "normal', and they cycle ok, but if I seat them just a touch further out, they chamber, but the bullet is engaging the rifling enough to make it impossible to... Read more ..read more

Stock arrived today and I was quite a bit Pissed to say the least after a call and email I am to recieve a 50% rebate. I specifically ask for these things to be done ONLY. 1= inlet for barreled action for Vanguard short action and add a forearm tip blank/Chunk of wood. 2= cut rough shape approximately 20-30% of your Monte Carlo stock leaving extra wood. 3= install recoil pad again 20-30% to match rough cut. 4= add sling swivels to package but not installed. NOTE: Customer will shape stock... Read more ..read more

Looking for a smith with a good reputation working with rifles, to rebarrel a Kimber 84M. Currently have a factory barreled action with an 0.470 bolt face and a Lilja blank. Need the blank threaded for the action and the thing chambered to 6 Creed min headspace. Finishing a plus but not a deal breaker as I will likely paint it at some point. I'm DFW area and would prefer someone local, but will ship if needed. Thanks ..read more

Here's a couple of pics. of the holes in the top rib of a Stoeger Double Defense shotgun into which I'm supposed to be able to attach a pic. rail. What/why are those inserts that are stopping me from inserting the screws provided?....and how do I get rid of them ..read more