Hi, I, well the extremely talented Paul from this forum, are having a few issues with coding the door mirrors to fold on locking and unfold on engine start up. The first set of instructions - see below - activated the folding mirrors, but the window switches on the drivers door went haywire. The drivers side window switch operated the passenger window and the switch for the passenger window on the drivers side did nothing. I couldn't open the... Read more ..read more

Wondering if anyone is local to Manchester / Stockport today or Glasgow after today that would be able to code the reverse parking display with VAG? It's a long shot but thought i would ask as I'm in Manchester just now before heading back to Glasgow.. So if anyone could help me that would be amazing ..read more

Hi New to here and a complete novice with car electrics. I have a 2018 A3 S-Line saloon RHS drive (UK). About a month ago i received a stack of error messages on the dash, initially all my interior lights failed - no footwell, boot, vanity mirrors etc and the dash dimmed upon starting the car; then some exterior lights stopped working - front indicator lights and side lights. Dash errors now say that “vehicle lights malfunction”, “front right turn signal”, “front left turn signal”, “front... Read more ..read more

I've got 2 faults from my S6 and I'm looking to see if anyone knows where I should start my investigations, what might be the probable cause or if anyone's had a similar issue? Any and all ideas are welcomed. P000B: "B" Camshaft Position Slow Response (Bank 1) - Implausible Signal P0011: A Camshaft (Bank 1) Timing over-advanced or System Performance - No signal/communication Thanks in advance ..read more

hello everyone, hope all is well I'm trying to put a new key in the car, but I don't know its PiN, nor how to configure it, can anyone help me? car: audi a3 8P 2010 VDO cluster Thanks [emoji41] Enviado do meu iPhone usando o Tapatalk ..read more

I have recently purchased a 2007 Audi S6 C6 with 98k miles on the clock, pretty much my dream Audi. There was a very bad oil leak from the oil filter and sump which the dealer kindly fixed free of charge and has stopped the leak. The car however has thrown an engine warning light and I'm looking for help on what might be the cause. The engine appeared to be rough running on standard E10 unleaded, moving over to E5 super unleaded petrol seems to have helped but the revs occasionally bounce... Read more ..read more

Hi all An anyone help. I am upgrading my prefacelift halogens to prefacelift led rear lights on my 2007 S5 V8... can anyone help with coding. I have been given the codes and have vcds but not sure how to go about it Thanks Mac ..read more

Hi folks i am a new member and was looking for some advice,i recentley had a glow plug warning light on the dash i scanned with vcds and got Turbocharger Boost Control Position Sensor Circuit P2563 00 [237] - Implausible Signal i bought a vacuum tester and have tested the acutator and it seems fine got over 500 mmhg vac and held it.i then disconnected the vacuum pipe from the acutator and started the car and was getting about 200mmhg vac so i am not sure if its the acutator or... Read more ..read more

Hello all! I could do with checking a few things on our A3 through VCDS but I don't have it, is there anybody that has very good VCDS knowledge that could help me out? Thanks ..read more

Good day everyone, I was hoping that I might get some help on the long code for my 2010 Audi A3 AWD S-Line Sporthatch. I recently changed the ABS control module and pump (had blinking brake lights, ABS, and ESP lights, with the usual error codes for a faulty module and/or pump. I believe that I have the old long code from my OBDEleven, but I'd like to confirm, before I install the used part that I purchased, and attempt coding it. Here are the numbers that I have located in the... Read more ..read more