Hi, I am away to do haldex service and belive I need to prime the pump after and top back up to level. Which VCDS do you all recommend that I buy as I would like my own one for future use also ..read more

Hi I’ve had the following code pop up on an s3 I’ve just bought. The tracking seems to be badly out would you guys happen to know If this is linked to this code ..read more

Anyone in the area can do taillights animation on a 2023 Sent from my iPhone using Tapatalk ..read more

Hi I’ve an 8V 2016 model, getting some faults listed on the past 3 scans. Fired engine check light past 2 occasions. Recently had new battery, as last one died, so thought that’s what these faults were from. Since then been cleared twice and came back twice.. Not sure what this implausible signal issue is or what could be causing it? And whether or not the struck lean o2 issue is just a coincidence or actually just firing because of the signal issue [emoji2370] Please help, no idea on... Implausible signal ..read more

Hi all, I have an Audi s3 8y just recently purchased. Not sure if this is the right area to post this so sorry in advance. Just wondering if it is normal for the car to idle higher when running warm. I noticed it happening when I was using my MMI system. Any help would be much appreciated ..read more

at times you might notice you have no traction in the rear or if you did a service. i recommend that you do this to reset the pump. most of the time people think the pump is broken and not working. this usually will solve the issue. with vcds: get the engein & haldex warmed up to temp leave engine on while doing the coding reset 22 awd 04 basic settings drop down - pump motor go you'll listen for the rear haldex pump prime. it will take a few. so let it finish on its own. do not interrupt... vcds coding to reset and prime haldex ..read more

As above I have a 2009 Audi S38PA the service light came up on the dash I have been into the service light reset with VCDS and it will not clear?? Says service reset on VCDS However when I Key on and off the spanner icon is still on and says service due ..read more