Anyone running a cx2510 with a tiller? I've been looking for a 48" or 50" rear discharge. I hear good things about certain brands but then bad as well. Hoping ti fund some reviews from actual users ..read more

Looking for recommendations on haying with a Kioto LK3054. I've had the LK3054 for 16 years and it has been great for clearing brush, maintaining gravel driveways, removing snow, pulling a manure spreader, and pulling stuck-trucks from mud. We are looking to start hay-making on our 3-5 acres of pasture for our horses. I'm torn between using used-smaller cutting & baling equipment like John Deere or New Holland (but I'm not sure of the HP needs) or getting new & smaller Chinese, Indian, or... Read more ..read more

Ok so here goes. I started my little CK20HST up yesterday. Drove down the hill to do some weedeating, set the brake went to shut her down but she didn't want to. I'm assuming the ignition switch is faulty. It'll start up with no issues. But I have to pull the fuel shut off to get it to stop. My question is has anybody else dealt with this? How hard is it to replace? Cost & availability of the switch? I've heard of other tractors running for ever but this little kioti takes the cake ..read more

Looking for any DK35 users out there. Have questions and can't find answers. Is your 35 tach driven by cable or magnetic pickup? Ever have issues with the tach? My 35 serial number says its an 2003, bought in 2005, wired like a 2007 35SE. What the heck? My 2003 35 workshop manual does not even show the tach in the electrical diagram. Ahhhhh!! Help ..read more

So I just installed a WR Long 3rd function on my DK6010SE HST cab w/5521 loader. Now the damn joystick is frozen in place; will not move up, down, or to either side. I'm hoping the solution is something dumbly simple that I'm overlooking, and not done major malfunction in the loader valve. I did notice that it seemed frozen while I was tearing apart the joystick to replace the handle with the one provided in the kit if that information helps; i.e. I'm pretty sure it was in that state... Read more ..read more

Hi, New guy here. Just looked at my first tractor from a private seller. It’s a CK2610 and has 99 hours on it so it’s due for its 100 hour service. Owner said he never changed the fluids and filters at 50 hours but everything looks dang near new. Would you be skeptical of purchasing a tractor like that? I checked the engine oil and it was good but wasn’t sure if it would be a gamble. Edit: the first thing I’d probably do is take it to a local dealer for a check over and have the services... Read more ..read more

Loaded my CX on my dump trailer for the first time and I’d say this is a snug fit! Not even 1/2” to spare!! Gotta say, sure pulls nice though! Glad I picked this trailer up off a buddy last year, it’s really useful ..read more

Is a 6ft landscape rake too much for a CS2220? The one I am looking at I think is 220 pounds 3 pt ..read more

My Kioti DK 40 clunks when four-wheel-drive is either engaged or disengaged. It seems to me that the noise is getting louder. Is there anything I should be looking for or at to prevent an expensive fix ..read more

I've made the repairs to the engine interface plate hardware and crank shaft bearing cover, with new seals and hardware. view"ck20 clutch post" Now I'm investigating the snap ring on the drain plug issue. I've removed the 3 pt hitch hydraulic assembly and nothing appears to be out of place. Once again I'm puzzled ..read more