Scrollsaw Workshop Community Forum
32 FOLLOWERS
This is a community for scrollers all over the world to meet. If you are looking for a pattern, let the community help you find it. Further, share your toy project ideas here.
Scrollsaw Workshop Community Forum
1w ago
Want to make nameplates to give out, but need way to put letters on board. Trying to download Steve’s printer stencil on my iPad but can’t get it done. Will it download on an iPad? If so how? If not where can I get something that will do that. Really a ..read more
Scrollsaw Workshop Community Forum
1M ago
The 2nd saw worked fine at first, but after a few days it started making overly aggressive cuts. It was impossible to make tight turns no matter what wood or blade I used. I returned it to Amazon and it took three weeks to get a refund. I've taken my o ..read more
Scrollsaw Workshop Community Forum
1M ago
thanks for your help. i'll remember this the next time i need one. thanks ..read more
Scrollsaw Workshop Community Forum
1M ago
I've collected a box (3-4 pounds) of assorted scraps from other projects that I deemed were too large to throw away, but too small for most scroll projects. It's mostly 1/4" - walnut, cherry, maple, poplar, basswood, oak. Also are some 3/4" pieces of ..read more
Scrollsaw Workshop Community Forum
1M ago
The new discounted DeWalt scroll saw was delivered yesterday. The blades were a bit closer together than the first saw. It was hard to hold the camera phone and the measuring tape at the same time, but it looks like the blade distance is about 4 1/2 to ..read more
Scrollsaw Workshop Community Forum
2M ago
I've seen some terrific work on this and other sites using patterns by Jim Blume, but I can't find a site for his patterns. Does anyone know where I can find them on the web? I would love to see what Jim has to offer ..read more
Scrollsaw Workshop Community Forum
2M ago
The on/off switch can collect dust over time and fail and you said that it's the original if I'm reading your post right. I had to replace one a few years back. There's a video on testing the switch and replacing it. https://www.youtube.com/watch?v=Qih ..read more
Scrollsaw Workshop Community Forum
2M ago
The tension was set all the way down and the blade clamps were in the right places. I used a couple of different blades to make sure it wasn't a blade that was too short. I really didn't want to send it back because when I was successful in getting a b ..read more
Scrollsaw Workshop Community Forum
2M ago
Have you checked a couple of things, like is the tension all the way up to 5 or above? That tries to raise the upper arm to increase tension and without a blade it can increase the separation. That being said, I have experienced this one other time. I ..read more