Old tecumseh motor question
Reddit » Go Karts
by /u/FamiliarAssumption35
9h ago
I picked up an old snowblower on the side of the road. The motor has compression and I am waiting on a new carb. When I was tearing into it to figure out what was seized in the driveline I noticed that it has two shafts coming out of the motor. One spinning clockwise and the other counter clockwise. Assuming their is a geared inside it. Has anyone used this to run reverse? Or multiple speeds? submitted by /u/FamiliarAssumption35 [visit reddit] [comments ..read more
Visit website
I know it’s an older hammer head but that’s it, what would be the easy motor to swap into it not sure what motor is currently on it any help would be appreciated thanks
Reddit » Go Karts
by /u/czbaby223
9h ago
submitted by /u/czbaby223 [visit reddit] [comments ..read more
Visit website
Does anyone know how to wire a killswitch on a vangaurd 16 hp v-twin, or what these wires do? Not looking to get the starter going just something to shut the engine down.
Reddit » Go Karts
by /u/Fragrant-Community89
9h ago
submitted by /u/Fragrant-Community89 [visit reddit] [comments ..read more
Visit website
Go kart engine questions.
Reddit » Go Karts
by /u/Josh_EndGamer
12h ago
I am building a go kart and I'm wondering if a stock 301cc predator engine with a 40 series torque converter will be faster or slower than a stage one tilotson 212cc engine with a 40 series torque converter. submitted by /u/Josh_EndGamer [visit reddit] [comments ..read more
Visit website
Deal or no deal?
Reddit » Go Karts
by /u/Fragrant_Industry_67
18h ago
Picked this up last week for $450. I believe it's an older hammerhead gts 150. Runs good but needs the reverse cable attached, the cvt times (only goes ~15 or 20mph) and the rear calipers seems seized. submitted by /u/Fragrant_Industry_67 [visit reddit] [comments ..read more
Visit website
How do I attach the governor to the new carb I got? Use the stock part?
Reddit » Go Karts
by /u/money_yakob
1d ago
submitted by /u/money_yakob [visit reddit] [comments ..read more
Visit website
Lawnmower engine ?
Reddit » Go Karts
by /u/Few_Park9292
1d ago
Hey guys I’m New to this group but was wondering if I could use this motor or need to make some changes look like the shaft isn’t long enough to put a clutch on but if there is a clutch please let me know one that would fit it your advice submitted by /u/Few_Park9292 [visit reddit] [comments ..read more
Visit website
Engine knock
Reddit » Go Karts
by /u/TragicPhoenix1
1d ago
Engine seems to bog down at full throttle and make a knocking sound. This is after I shortened the throttle cable a little and enlarged the carb jet and cleaned the carb. submitted by /u/TragicPhoenix1 [visit reddit] [comments ..read more
Visit website
Any idea what kind this is ?
Reddit » Go Karts
by /u/whatisthiscrap2020
1d ago
submitted by /u/whatisthiscrap2020 [visit reddit] [comments ..read more
Visit website
How to remove wet clutch
Reddit » Go Karts
by /u/doasyoulike
2d ago
Any tips on removing this type of clutch? https://preview.redd.it/nfwn64428yxc1.jpg?width=4000&format=pjpg&auto=webp&s=d4a8a2722ac26f31d90c59ea174bebd1590fdd37 submitted by /u/doasyoulike [visit reddit] [comments ..read more
Visit website

Follow Reddit » Go Karts on FeedSpot

Continue with Google
Continue with Apple
OR