Service: Looking for assistance for ZO sensor and roller adjustment for unit. Located in Farmington Hills MI 248-324-3090 Mike ..read more

I am getting error Plate didn't reach W0 sensor. None x-ray repair people wants to fix my Kodak CR POC 140. What could be wrong? Problem with Sensor or roller motor ..read more

Continuous roller motor motion when CR is turned on When I turn on my Kodak POC 140 CR, the Roller motor turns CONTINUOUSLY and I get an UNLOADING PLATE message on the Kodak QC and no further booting occurs. On the diagnostic screen the W0511 light is permanently on. The Z0505 light is also permanently on. Please how can I stop the roller from continuous motion? Also when I Open the _Diagnostics_ screen in the Kodak QC and move the Screen Guide up and down and check the Z0505 light in the _Diagnostics_ screen, it DOESN_T turn on and off. The Z0 light on the sensor DOESN_T turn on at all. Pleas ..read more

rollers fail to stop spinning on power up of kodak poc 140 The motor rollers fail to stop spinning on power up of kodak poc 140 CR. Please what can be done to stop this from happening? Please help ..read more

No image produced when cassette is exposed and scanned with Kodak poc 140 When cassette is exposed, no image is seen following scanning. What shows is only noise or a dark area at most. Any one had this problem? What component needs to be changed ..read more

Problem connecting kodak poc 140 with agfa drystar 4500M printer Please can I get help with the necessary dicom and printer settings that enable an agfa drystar 4500M printer connect with a kodak poc 140 (kodak QC software version 2.4)? I've tried everything and printer wont just print from kodak QC ..read more

Have a Kodak Point of Care 140 and it will not turn on and film is still in machine. Call office 248-324-3090 to set up appointment to fix problem. Live in Farmington Hills, MI ..read more