I've been gagging to get back to the Gridworks, this is only my 2nd time here but so far no other bando beats it, shame the roof crevices were full of water as I wanted to get some dives in. Wrecked a load of stuff, anyone who knows this place knows it is brutal, still I already can't wait to get back there, @SupaflyFPV Flipmode taken yet another beating and still going strong, can't say the same for the motors though! ? Big up @HoltBlackheathFPV & @StevePhillips1890 , was a sick one as always lads! submitted by /u/rdubble [visit reddit] [comments ..read more

submitted by /u/SCOTTFPV [visit reddit] [comments ..read more

​ https://reddit.com/link/1ciipdc/video/002folul81yc1/player submitted by /u/justsomefpvnoob [visit reddit] [comments ..read more

Been out with my gang and had some fun. Would really appreciate if you could give me some tips to improve thanks guys. submitted by /u/Alex4erer [visit reddit] [comments ..read more

submitted by /u/whutisreal [visit reddit] [comments ..read more

Hi, I’m very new and I would like to build my own drone, I can solder and 3d print or whatever necessary really. I’m not sure where to start. I have a budget of around 200 for the drone, I’d like to go fast and far. When I learned to build pcs I used pcpartpicker to help is there any website like that for drone building? Or where do I even start? Thanks for reading. :D submitted by /u/Not_A_RedditPerson [visit reddit] [comments ..read more

submitted by /u/gizlonkFPV [visit reddit] [comments ..read more

So, I tried an action cam for the first time yesterday, and found out for some reasons, the drone stutters to the left when I mount it. The action cam is probably a bit on the heavy side, and obviously with the end of the video, the mount was a bit brittle (I printed it using PETG, though it would last, good thing I took it easy to test before sending it). Here's the video from my DVR, the issue is mostly noticeable around 28 seconds. I'm a bit hesitant as to why it would do that. It flies perfectly fine without an action cam. Could it be too heavy ? Could the high center of gravity with prob ..read more

submitted by /u/Ndjdjdndd2 [visit reddit] [comments ..read more

I've never flown a drone before. I am into RC cars and have wanted to get into FPV drones for years. It's finally time. I am building my first 5" FPV drone and would appreciate any feedback that you all can provide. Frame: MARK4 Mark HD 5 Inch 240mm 3k Carbon Fiber FC and ESC stack: Speedybee F403 V4 & 55A ESC Motors: 4x T-Motor Velox V3 2207 6S 1750KV VTX: Rush Tank Race Edition 5.8GHz 48CH PIT/25/50/100/200mW Camera: RunCam Phoenix 2 SE Receiver: BetaFPV ELRS Lite RX Tower Antenna Battery: 2x CNHL 6S Lipo Battery 1300mAh 22.2V 100C Black Series Props: Assorted Radio: Radiomaster Pocket ..read more