Hey I see a lot of people diving on the surface of the sea. Does this affect the Motor ,FC ,ESC , etc ..read more

Hey Why do higher voltage batteries need lower KV motors ..read more

Hy, i have just flashed INAV 7.1.0 to my speedybee 405 stack for my 7 inch long range quad, and i run it for a test flight that resulted in a crash close to my home position (i was inside a building), and i has failsafe set to return to home them land. The box for alternate option in case of failsafe close to home was unticked, so i set it to DROP and it work now. My problem was that for some reason, my flysky fs i6x with added elrs module, set on 50 hz update rate, was communicatig pretty slow with the quad, the arming/disarmin had a noticeable delay (like seconds from when i disarm ..read more

My current setup  Speedybee tx800 Speedybee cloverleaf on VTX and vtr An old eachine screen single receiver  My current plan Foxeer 2.5 or 5w with cloverleaf Ev800dm With one cloverleaf and one high gain antenna ( helical or patch) Does this setup make sense ..read more

Hello. If anyone has a dump file for iFlight Nazgul Evoque F5D 6s TBS Vista GPS, please give it to me. I installed Vista Polar on my drone and flashed it, and after that I realized that it flies worse, since it has standard settings. Now I'm looking for a dump file for it to restore all factory settings.   IMG_20240422_100132.jpg (Size: 455.12 KB / Downloads: 1 ..read more

Hi all I recently replaced my Flight controller after breaking my last one. Its the same on that was previously installed so installation was easy. Everything is working normally after configuring everything in Betaflight but I'm unable to get my Video TX to work. I copied all the same settings from my previous FC but still no luck. Any help would be appreciated. FC - IFlight Blitz F7 v1.2 VTX - IFlight Blitz VTX 1.6W   Capture.PNG (Size: 110.62 KB / Downloads: 0)   Capture 2.PNG (Size: 152.55 KB / Downloads: 0 ..read more

m getting about 3min and 30 second flight time with my cinewoop. im running a speedybee bee 35 frame speedybee 2006 1950kv motors iflight succex-e f405 stack vista with polar cammera tbs crosfire nano rx 1300mah lipo i have seen people get 7 min flight times with almost the same setup only difference is they mostly run a speedybee f405 mini 35a 20x20 stack. And im only geting 3,5 mins i dont know how anyone has anny ideas why? thanks in advance, Mark ..read more

I am still awaiting some parts but decided to build something more for indoors (the addiction continues as 19 quads apparently isn't enough). I have two sets of motors and not sure which will be used. I am going to try both and whichever gets the longest flight time wins... The only place I could find the flight controller was AliExpress. This is my first time dealing with them and I noticed it was a week before the fc was even shipped. I am still waiting on the fc and the Tiny Whoop 603 motors. Tiny Whoop does not give a weight for the motors so I will weigh one when they arrive. Here is th ..read more

Hello, I encountered an issue when connecting TBS Unify Pro32 HV analogue VTX and SpeedyBee F405 FC + ESC stack. I soldered exactly as instucted and in TBS Agent selected Smart Audio in Data Port setting, also uploaded LUA from TBS website that should be correct:  FC -> VTX ========= 9V->7Vto26V GND->GND GND->GND VTX->VIDEO T1->CRSF/SMARTAUDIO There are three wierd things that I'd like to solve.  1) why is there Devise Ready: False message 2) why do I see a camera feed in goggles, but no OSD 3) why is there an VTX(MSP+Display port) setting that is impossible to ..read more

Took a few minutes to view flight video from my goggles SD card…. And I found footage that I’m not exactly crazy about. 2 parts in particular and I was curious what people think is the worst one… I had JUST installed a new esc on my 6s rig.. charged 2 lipos and ran outside to get some stick time… No more than 10-15 seconds into the first pack…I stuck it in a tree about 25feet up.. trying to decide if watching the footage of me putting it in the tree is worst than having it hang facing straight down … and watching myself looking UP at it in the tree ..read more