As per title, can't find a definition on the forum ..read more

I am installing a Ford/Lincoln 9 inch rear end out of a 1977 (I think!) into a chassis for a 1932 Ford Street Rod.  I purchased this rear 35+ years ago, and don't seem to recall the configuration for the Emergency/Parking Brake lever on the rear caliper??  Has anyone done this - in their lifetime and can help??   Tony T ..read more

Hi everyone. I have a 1996 Ford Probe. 2.5 V6 The probe passed his MOT yesterday but I am a bit concerned about one of the advisories. Blue smoke on acceleration I have looked up the possibilities and it’s says to check the seals and piston rings.  is it something I should be worried about.  The Tester told me it’s because I don’t take it out enough. To be fair it has only done about 50 miles in the last year!! I know I’m supposed to take it out more, but I’m very protective of him and there are so many idiots on the road now. I have taken the probe to the same garage for years a ..read more

Hiya all  my mum remembers her dads reg as DYF 744 or DYF 544 and they lived in Folkestone in Kent in the 1940’s. Can anyone help point me in the right direction to find out if it still exists? Or even what model it may have been ?  many thanks in advance  cheers Ethel ..read more

The general population aren't going to look on Autotrader oe eBay for such a car ..read more

Unsure if this is a 1.6, anyone know ..read more

Need help to settle a friendly argument. A friend of mine recons he had a 2tone Corsair V4 with a front bench seat and a column gear change, I said Ford never produced a Corsair with 2tone paint and a column shift, but he is adamant they did. your thoughts please ..read more

I am after an air filter outlet pipe for my 2.5 v6 mk3 mondeo,can anybody help me find one?Apparently they are discontinued.Any help in locating one would be much appreciated.Many thanks,Keith ..read more

Hi all, I am looking for a recommendation for a local garage to MOT and look after my 1991 Granada Scorpio. Am hoping to also have some minor  restoration bits done too. New door seals, etc. Any recommendations welcome in the Denham / Gerrard's Cross / Beaconsfield area of South Buckinghamshire. Thanks ..read more

Trying to find a replacement BRAKE BOOSTER for a 1949 F-6.  Existing Midland Hydrovac diaphragm is bad, and a lot of rust.  Can't find anyone to refurbish existing since diaphragm availability is not there according to refurbish shops, so looking for what might work as a replacement ..read more