I'm looking to buy a CZ 2075 Rami. Please let me know if you have one for sale ..read more

Hi, I'm wondering if anyone makes an extended mag release for the 75/85. My CZ is an 85 combat and yes it has the extended mag release and yes I need one that's even more "extended" Perhaps one that also offset towards the pistol grip also. Thanks ..read more

New 75 BD Decocker is not functioning due to a pin alignment problem. When I press down the decocker tab, the hammer only travels a minimal amount. I can take my fingernail a lightly push the pin on the right side of the frame and the hammer fully decocks. Any thoughts ? Is this just a situation of the gun being new and tight ? Thanks ..read more

i have a cz p09 i like is there a way to take out the pr travel out of these trigger ..read more

Hola, I am trying to get some extra mags. These would be range/training mags. I have three CZ factory mags right now and want to keep them pretty, just for EDC. To that end I know that I can use CZ-75 mags (I have one by Mec-Gar) but was wondering if there was anything else that would work? Again, not a carry mag, just something to bang around at the range. Thank you ..read more

Been looking at CZ’s for a while gun store out of DB 75”s so I ended up getting a C-10 my friend loves his so I figured why not try one. ran 10 shots 115gr at 15 yards all in a 6 inch square not bad for a striker. We will run some 124gr tomorrow and see how it does ..read more

I've had my K12 for a while now and love it. Time to upgrade. I know PewPew had an old post outlining most of his finding but seeing as that was from 2021 I'm looking for new info. Is there a common consensus on what is interchangeable seeing as this is a CZ clone? Mainly looking for other triggers that work as well as to replace the plastic thumb safety. Everything else on PewPew's list would work but not a huge fan of the Tanfoglio trigger. Any leads would be greatly appreciated ..read more

I recently purchased from cgw: reduced hammer spring #13 entended firing pin reduced trs upgraded firing pin retaining pin Question - Do I need to do anything at all with the firing pin block plunger spring? Some videos I see include this spring as a part of this upgrade, and some don’t. What would be reason for changing? Thanks - I look forward to reading the comments ..read more

..read more

Anybody familiar with the Spinco guide rod system for a cz sp01 ..read more