I have a 19.3 as my EDC with a WMW acro cut, radian ramjet/afterburner, ghost maritime spring cups, Vickers slide stop, and Vickers mag release as the only "modifications". Every so often when clearing my gun the extractor is stuck in the "open" position and will not catch the round. Depressing the trigger so the trigger bar pushes up on the safety plunger causes the extractor to "close" immediately. Any idea what could be causing this? submitted by /u/Cold_Organization262 [visit reddit] [comments ..read more

Anyone know where to get a cheap dry fire mag for my 19? I see them from $80-$100 and was wondering if there’s any cheaper ones that anyone has experience with. submitted by /u/AdPale1239 [visit reddit] [comments ..read more

This is by far my favorite Reddit page I’ve been on. If no one told you that they appreciate you today that’s what I’m doing now. Thanks for all the great input you fuckin animals submitted by /u/Inevitable_Comb9666 [visit reddit] [comments ..read more

Not new to glocks but I’ve been wanting to get my hands on a 47 or 45 for a while now submitted by /u/sgtskitz [visit reddit] [comments ..read more

Looking for recommendations for an IWB holster for glock 19. What do you guys like and what should I stay away from. Please post pics of holsters if you have them. submitted by /u/Imaginary-Gap-18 [visit reddit] [comments ..read more

https://imgur.com/a/fF29Xqo I'm about to send off my glock to have the slide milled for a holosun EPS. I am looking at battlewerx and wager machine works. My question is about the sight height. Battlewerx optic cut is .170" and they recommend .180" front /.256" Rear. Wager optics cut is .125"and they recommend .220" front .225" Rear. I am looking to get a lower 1/4 cowitness like the photo. Wouldn't the two has vastly different point of impacts with such a disparity in the sights height? (Wager being almost the same front and rear and battlewerx being so different) Am I missing something? Som ..read more

Can anyone tell me definitively what parts are NOT interchangeable between the 43 and 43x? Specifically the slide stop, mostly, but the rest of the parts would be good to know. submitted by /u/Self-MadeRmry [visit reddit] [comments ..read more

Any pictures/info of sight set ups for G19.5 MOS with a CHPWS plate (GL-EPS) with a Holosun (not carry) EPS? Looking for 1/4 to 1/3 co-witness plain black iron sights. TIA. submitted by /u/Electronic_Green2953 [visit reddit] [comments ..read more

My G19.4 and G45 carry the 45 with tlr1 pretty much full time just need em both milled and an optic mounted! submitted by /u/Frosty_Raspberry158 [visit reddit] [comments ..read more

submitted by /u/214jonathan1 [visit reddit] [comments ..read more