Can-Am ATV & UTV Forums » Commander General
56 FOLLOWERS
This category of the forum is dedicated to discussing Can-Am Commander UTV SxS. Also, chat about Commander XT 700 clutch tools, Commander 1000 4x4, Commander XTP, and more here.
Can-Am ATV & UTV Forums » Commander General
3M ago
Hello I have a commander 1000 and after it warms up idling for about an hour or riding for 20 it dies out and has a hard crank won’t turn over fast enough to start. Once it cools down starts perfectly and does the same thing. Any ideas ..read more
Can-Am ATV & UTV Forums » Commander General
7M ago
2011 Can Am Commander 1000XT. It will rev up full throttle in neutral but when in gear won't go over 40 mph. Key has been reprogrammed, new fuel pump, new spark plugs and still the same issue. Any one have any other suggestion ..read more
Can-Am ATV & UTV Forums » Commander General
7M ago
Hello
My commander 1000 Rotrax is geting heat.
Thermostat is new
Vent is working
Radiatir was clean
Watre pump is round well.
What is the problem?
Thanks
Shahar ..read more
Can-Am ATV & UTV Forums » Commander General
9M ago
No spark I got power to coil and I got new coil and plugs and wires still no spark ..read more
Can-Am ATV & UTV Forums » Commander General
9M ago
Hey peeps. I have the following fault codes showing up and sxs is going into limp home mode. Has anyone had the same problem?
Fault Codes:
P3002
P3005
P3012
P3015
P30D3
Cheers ..read more
Can-Am ATV & UTV Forums » Commander General
1y ago
Hello All, I have a 2013 Commander XT800 that is occasionally and getting more frequent will grind when when accelerating after it has appeared to go into proper gear. I have had the linkage tested and verified to be correct. Again it's not a noticeable problem as far as putting into gear, feels and sounds fine at idle, but once I try to accelerate it may or may not grind like its out of gear. Have been told it is probably internal, just checking with the group before I go that deep into...
Transmission Grinding ..read more
Can-Am ATV & UTV Forums » Commander General
1y ago
Replacing the sprag on my unit, and want to make sure i am putting it on correctly. I have heard it can go on backwards. My question is, does it free spin only counterclockwise and doesn't turn clockwise? So when i bolt it up to the back of the flywheel it should fit nice and snug inside it flat, and the bulge should go against the starter gear? I got one from can am parts guy and it shows to have an arrow on it.
Thanks for any help i can get. And picks or videos would be awesome...
Starter sprag ..read more
Can-Am ATV & UTV Forums » Commander General
2y ago
Hi there, I'm new to the group and Can-Am machines. I recently purchased a 2011 Commander 1000 and when I tried it out for a test drive the 4x4 mode and transmission position indicator on the dash all worked. Now that I have it, I can not get it into 4x4 (front wheels are not engaging) and the dash always stays on 4x4 even when selecting 2wd on the button. I can hear the actuator moving and all my lights work. I am stumped as to what could be the issue. It does have a new "Super ATV 6" lift...
2011 Commander 1000 4x4 not engaging ..read more
Can-Am ATV & UTV Forums » Commander General
2y ago
Any one buy one yet ? I may be purchasing one tomorrow and was wondering what Size trailer I can get away with ..read more
Can-Am ATV & UTV Forums » Commander General
2y ago
Anyone know the torch on the crankshaft rod bolts ..read more