As stated, I can’t go into reverse without it rattling and not fully engaging. I have figured out that if I go from forward and keep pressure up on the shifter and I can throw I to reverse quickly and it does engage. Just wondering if anyone else had had or seen this problem before and how they figured it out. Or if it’s just one of those things ..read more

Hi Guys, First post here. I recently inherited a 2011 Rubicon 500 from my Father In Law. The bike has extremely low mileage on it and has always been serviced at the local Honda dealership. When I picked up the bike I was getting the 5 code flashing on the dash. After some trouble shooting I found the control motor was. Shot. I replaced it and the bike ran fine for a day or 2. We then got a code 6 flashing on the dash. I installed a new angle sensor and did the Initial setting... 2011 Rubicon Code 6 ..read more

I have an 03 Rincon 650 and need some basic understanding about the ECM's. There is an ECM type box with 2 plugs, for the auto transmission shifting, correct? Also, there is another single plug box that is the system ECM? Is this box also called the CDI? Are they the same thing ..read more

Hello. I need a Rincon 650 mechanic in Houston Texas. Thanks in advance ..read more

Battery good at 12.6V, solenoid good, but no power to the start switch, and no signal voltage getting to the solenoid. It started when I bought it, then one day didn't. All fuses have power. No power to the ignition wire going to the keyed switch. The display never worked, but when I bought it the green light came on when I turned the key. Now it doesn't, but the red light does. Is there a shifter safety switch?? I'm thinking a sensor or something simple here, but where do I start looking ..read more

Hey All, Longtime member but have been inactive for years. Im having issues with my 2007 Rincon. heres some backstory. i bought it new in 09 but it was an overstock from 07 (0 miles at purchase). right now it has less than 1000 miles on it and i keep a battery tender on is as its at a vacation home that i visit once a month roughly. Right now the bike wont start and i cant figure out why. My friend was riding it and left it idle as he was doing some fence work. it stalled out and hasnt... '07 Rincon not starting ..read more

Heya, anyone have a clue where I could get this piece? I found a very similar one online that says M48 instead of M5 but not sure if it would work. Thanks for any answers or knowledge in advance ..read more

i ride an 04 rincon that started having trouble pulling about a month before it stopped pulling entirely. we were at a riding park when i got mud in the radiator so it overheated. i switched it off and pulled it with a rzr back to the trailer. when i had to load it, it cranked just fine and ran perfectly. i put it into gear and tried to pull up, but it wouldn’t move. i’m not sure what’s wrong with it ..read more

I have a problem where I can’t go faster than 35 without it hitting limiter and it smokes a lot when I go 30 I freshly changed oil and have let it warm up for up to 10 minutes but it still smokes a lot what could be a problem that I have ..read more

I have a problem where I can’t go faster than 35 without it hitting limiter and it smokes a lot when I go 30 I freshly changed oil and have let it warm up for up to 10 minutes but it still smokes a lot what could be a problem that I have ..read more