Grizzly Owners Forums
23 FOLLOWERS
Yamaha Grizzly Forum is a community for Yamaha Grizzly enthusiasts including both street and track riders. Come in and talk about your favorite Grizzly models including 700, 660, 600, 350, and 125.
Grizzly Owners Forums
1d ago
Hey again guys ,, Having alot of problems with this machine lately,, arhh,, Every once in a while when i drive it ,, it would let out a POP ,, little backfire out thru the carb AND sometimes blow the carb off the intake !!!!!!! ,, so i bought a Carb rebuild kit and put in it today,, ,, now it backfires all the time,,,and blows the carb off still,,, Never even driven it yet cause it keeps backfiring and blowing carb off ,,& does n e one know what to set the JET NEEDLE clip at and what...
Backfiring thru the CARB !!! Yam 600 Grizz ..read more
Grizzly Owners Forums
2w ago
Hello, I‘m searching for info on what I think is an oil leak coming from the rear driveshaft seal ( where it exits the rear of the engine or what may be considered the transfer case). I started noticing an oil stain under my grizzly, it seems to be dripping from what I believe is a dust cover/boot that covers the rear driveshaft. It appears to be quite a job, just to access the seal. I‘m looking for advice from anyone that’s replaced this seal on this old of a machine. Biggest question is...
1999 Grizzly 600 rear driveshaft seal oil leak ..read more
Grizzly Owners Forums
2w ago
Do I need the instrument cluster hooked up in order to crank the engine over ..read more
Grizzly Owners Forums
2w ago
I've read dozens of posts on gas tanks overheating or vapor locking but they're all older bikes with slightly different problems so I thought I would post my scenario and maybe someone could comment based on my story instead of speculating based off other's.
Bought almost new, 5000km's ago. Installed a rad relocate and snorkel kit 4 years ago (never had issues with how it ran). Boyfriends Dad did a big tune-up 2 years ago because my 4x4 would engage randomly on it's own (stripped it all...
2015 Grizzly 700 gas tank vapor lock/overheat/pressure issue ..read more
Grizzly Owners Forums
3w ago
I am having the standard backfiring problem so many have described, i solved this years ago by adjusting the needle position. I now have a worn out needle and slide that don’t seem to available through the usual channels,”. Does anyone now where to get parts ? and who built it ? Thanks ..read more
Grizzly Owners Forums
3w ago
I have a Grizzly 660 that I had to rebuild the carburetor on. It was previously super rusty inside and didn't run worth anything. After rebuild it worked fantastic for a couple months. Ran fast, could go full throttle and power was extraordinary. Was driving it back to my house and it suddenly died. There was a sound of backfiring out the top of the engine under the gas tank. Turns out the person I bought it from must not have tightened the spark plug all the way down as it shot out of...
Grizzly 660 bogs down/backfires when throttle is more than halfway ..read more
Grizzly Owners Forums
3w ago
I hail from Bristol Virginia trying to get my grizzly going ..read more
Grizzly Owners Forums
3w ago
OK peeps,
What are the most common issues with the 2000 grizzly 600? What are the things you guys have done to fix or avoid the issues ..read more
Grizzly Owners Forums
1M ago
I just purchased a used 98 yamaha grizzly 600. Can anyone tell me where I can find an exploded view of the shifter box? The shaft where the linkage hooked on works its way out the the shifter box itself. I can't figure out what holds in in. Thank for any and all help ..read more
Grizzly Owners Forums
3M ago
Anyone running a Dyno jet power commander -6 Good bad or better one to use ? Grizzly 700 2023 and a 2024 its his and hers ..read more