Referring to: http://www.bluetraxx.com/forums/yam...resent/90922-1987-warrior-350x-need-help.html Still no spark after changing everything electrical except harness. Found out that the wires were bad in the cutoff switch and were not making contact all the time, so got a new one and fixed it. Now I know you can't really test a CDI BOX, but i tried the following test just to see the results. Multimeter 20k volts: POS to cdi orange wire - NEG to Coil... '87 yamaha warrior no spark issue ..read more

I got a full dg exhaust system for my 1989 Yamaha warrior 350 and it’s running so lean it will start and then die, just need help with adjusting the carb, thanks ..read more

Still no spark. I'm totally stumped with this thing, I’ve tried/checked everything, ohmed out wires, nothing I do seems to work, I'm not even getting any spark what so ever now. Bought an aftermarket stator, same ohm as stock one. Any advice would be greatly appreciated. Thanks in advance ..read more

I've been told it has a cut out encase the thumb throttle is blocked and the throttle stays on that's shrewd it will cut out. Would it cause the new motor to not start ..read more

Hello, I have a 2002 Warrior and I have done some research about the electrical problems that come with the warrior but this is a whole different problem that I'm not sure most will have an answer to. I have done a decent amount of electrical work on the warrior and am co confused on whats going on. Problem: Turned the quad on and put the key in turned it on, then flipped the switch to run clicked the starting button, nothing no click from solenoid or anything of that sort. Tried the... 2002 Warrior 350 Electrical problem - Lights will come but wont start ..read more

Welcome to the Forum!! Sounds like you got a good starter list, Lookin forward to the pics. Also Ebay and YFM350.com are both great places for parts ..read more

Had a carb that would only run on choke even after being cleaned. Replaced carb, plug, and unplugged the parking brake sensor. Still cuts out at a 1/4 throttle. Tried to screw air mix screw in until RPMs were too high. Backed the screw out a full turn and issue persists. Idles perfect off choke. Anything else I should try? Thanks ..read more

Any one on here know what other header pipe I can fit on my warrior I have been wanting a fmf powerbomb but they are discounted and I can't even find I used one. I have tried the raptor one also and no luck. Has anyone put a different make/model on the warrior with little to no fabrication done. Thanks for your help and interest ..read more

Just picked up a frame with all the electrical except the key switch and no motor but brand new tires 100 how can you go wrong I will post when I brea it down if you need anything from the front or rear brakes and arms hit me up. Thanks ..read more

I can't get the swing arm bolt to break lose, the nut is off and when I try to drive the bolt out it does not budge, wondering if the bushings have worn a groove that may be hanging it up. any suggestions????? please ..read more