Fingers crossed, we can use the new Datsun 240Z in this series.  BRM is allowing the Z to be used for their upcoming race in Italy.  Alan has already received some cars and will have them in store at the end of March ..read more

Brian, Those look amazing.  All of the pictures I have seen of them look great.  Marc received his before last weekend’s race.  It looked so good.  It’s hard not to see a RevoSlot series next year with these cars. Marty ..read more

I expect I’m not the only one who pre-ordered these.  ? Excited to get them on the track ..read more

Attention All Note as of 2-17-24 – The Slot.it G25 in the 11.3mm width was shown as an approved tire but that is not correct and it is no longer allowed to be used.  This is in keeping with the 10mm width maximum rear tire rule. Marty ..read more

Brian — Interesting alternative architecture, how many hundredths of a second did those mods “shave” (or should I say “melt”) Off ?       /* completely joking of course, some Shxt happens ..read more

like it … we need more volunteer info like this ..read more

To complete the required work on the club’s rally track, it was presented that the club not race in Q2 and use all of those existing race dates as workdays for everyone to come together to help complete the work on the rally track. As a quick reminder, the work remaining to be completed on the rally track looks like this: • Remove the timing bridge • Remove the existing copper take and remove any remaining tape residue • Route the braid relief • Paint the routed relief and the rest of the track • Install braid • Get all of the electronics working • Get the timing working • Landscaping o Instal ..read more

Was taking inventory of my tools the other day to see what I have and what I might be missing after all the moves over the past few years.  There’s a lot of overlap so I put together a quick matrix  make sure I only ordered what I needed.  Thought someone might find this useful. Attachments: Tool-Matrix-by-Popular-Brand.xlsx ..read more

Well… not sure what I’ll be running tomorrow.  I have graduated from melting a body with acetone to having a chassis melted in the oven.  I didn’t have the correct size aluminum pan to do the water bath so I was “air baking” it and had yet to retrieve the chassis from the oven when my wife preheated it for baking.  The results are what you would expect.  That said, it is FLAT! I think I have another Mazda chassis in the parts locker, but if not I’ll have to select a car from the archives.  (Thankfully, it is plenty deep.) This reply was modified 2 hours, 11 minutes a ..read more

Final DTM rules are posted ..read more