Cartaholics Golf Cart Forum
113 FOLLOWERS
The Golf Cart Forum is for the Golf Cart enthusiast to share Golf Cart wiring diagram and chatting about Golf Cart repair, troubleshooting, EZGO, Club Car, Yamaha, and all other Golf Carts.
Cartaholics Golf Cart Forum
9h ago
My 2005 carryall 294 is always in 4wd. Isn’t the intellitrak system supposed to be 2wd until needed ..read more
Cartaholics Golf Cart Forum
11h ago
I want to swap in an MJZ400 but it won’t fit in the standard location. Does anyone have experience and suggestion on the best place to mount the solenoid ..read more
Cartaholics Golf Cart Forum
16h ago
I'm helping a friend with this - there's been a previous repair attempt to the throttle/governor, and I'm not sure if the cables (which have been replaced before we got it) are in the right place. It starts and idles fine, but has a throttle problem.
This is a port fuel injected three cylinder, and when the TB pulley is rotated by hand, the engine responds to the throttle command fine, but the foot throttle pulls on a pivot plate (not to the TB directly) and that plate rotates, but does...
Read more ..read more
Cartaholics Golf Cart Forum
16h ago
Hello all,
Newbie here, I have the wiring diagram but do not understand how the newer style solenoid is hooked up as the posts are on the side, vs the diagram that has everything on the top both large and small posts. Also how to know which direction the diode and resistor go ..read more
Cartaholics Golf Cart Forum
18h ago
Hello all,
Newbie here, I have the wiring diagram but do not understand how the newer style solenoid is hooked up as the posts are on the side, vs the diagram that has everything on the top both large and small posts. Also how to know which direction the diode and resistor go ..read more
Cartaholics Golf Cart Forum
1d ago
My screen name is a bit misleading. I don't golf, so all I am here for is repairs. I don't typically work on golf carts. Anyway, I am working on a Melex 212 36V for a buddy.
-It has two new batteries and the other four tested good. The batteries are wired as per the resistor wiring schematic floated around for the 212 Melex. They were wired to 36V but in a different manner before I cleaned all the contacts, posts, etc, and tightened.
-The wiring has been messed with at some point as...
Read more ..read more
Cartaholics Golf Cart Forum
2d ago
Hello
Have a 97 Columbia Par Car Eagle. 48V Electric.
Can someone help me out.
Will extremely low gear oil with water in it make the rear feel like it is slipping or like the axle splines are stripped?
I have taken the right side axle shaft fully out and the splines seam good. I have not pulled the gears apart in the pumpkin. As of yet.
I have taken the cover off and got all the old fluid out.
Wondering what my next step should be.
Thank you in advance ..read more
Cartaholics Golf Cart Forum
2d ago
I have a 13hp Kawasaki engine from a 2008 EZ-GO, can't remember if the S/G is the one that came on it new.. the sticker is long gone, no other markings to know what brand it is, I've totally took it apart and cleaned, re lubed the bearings and added new brushes, but the inspection covers fell apart taking them off, I see a number of different ones on the web, how to find out what I have and get the right covers ?
Thanks ..read more
Cartaholics Golf Cart Forum
2d ago
I have a 13hp Kawasaki engine from a 2008 EZ-GO, can't remember if the S/G is the one that came on it new.. the sticker is long gone, no other markings to know what brand it is, I've totally took it apart and cleaned, re lubed the bearings and added new brushes, but the inspection covers fell apart taking them off, I see a number of different ones on the web, how to find out what I have and get the right covers ?
Thanks ..read more
Cartaholics Golf Cart Forum
2d ago
I will be storing my cart at the golf course, possibly a week or more between use. I can’t find a straight answer anywhere…can or should I leave the charger plugged in? It came with the Yamaha multistage charger/maintainer. P/N: JW9-82107-03
Thanks ..read more