As requested by a few. Here’s more detailed photos of my dodge coronet. It’s running dual carbs, not cammed unfortunately. With split headers and cherry bombs. I put pertronix ignition for a hotter spark. Upgraded to front discs and a two bowl master, for safety..It’s slow and low.. just like me. submitted by /u/PastWorld1744 [visit reddit] [comments ..read more

Anyone else’s buy things and save them. submitted by /u/UsefulBowler3477 [visit reddit] [comments ..read more

Hey guys! Hope I’m allowed to post this here, I’ve been running this 454 in my 68 Camaro for about 8 years now. Maybe driving 1 time a month for 30ish miles. So not too much mileage, but having a bit of fun. I know it’s been wayyy too long to check these plugs but today I pulled them and never seen something like this! The tips of 6/8 plugs are broken off. Never even noticed a loss of power and anything abnormal. Obviously this is pretty bad, my question is how bad?? I know that a LOADED question with so many variables! Let me know what you guys think! Picture is the passenger side, left ..read more

submitted by /u/PastWorld1744 [visit reddit] [comments ..read more

Can someone tell me what year make and model of this front end submitted by /u/Guilty-Document-3493 [visit reddit] [comments ..read more

submitted by /u/Guilty-Document-3493 [visit reddit] [comments ..read more

Are you ready to hit the road on June 10th for the Hot Rod Power Tour 2024? I've already booked my ticket, and I can't wait to experience the thrill of cruising across the USA. Have you secured your spot yet? If not, you should check out the Hot Rod Power Tour 2024 route map. It will be an epic journey filled with unforgettable memories and incredible sights. Join Hot Rod, and let's make some road trip magic together. Any suggestions let me know in the comment. submitted by /u/muneesh0811 [visit reddit] [comments ..read more

submitted by /u/what-isay123 [visit reddit] [comments ..read more

New to owning a carbureted vehicle, just bought this 94 K2500 Suburban with a carbed 400 SBC in it and it stalls out on me after it gets warmed up. Pop the air filter off and it seems like the fuel is boiling. It already has a thick heat insulator gasket, but should I add a spacer? Both coolant gauges don’t show it going over 212. The engine is a fresh rebuild with under 100 miles on it. Should I get a lower temp thermostat? I also haven’t check to see if it’s the 4 core radiator, but if it’s no, that’ll be getting changed out as well submitted by /u/TheDarkOne_2112 [visit reddit] [comme ..read more

1976 c10 short bed with an 81 front clip. Chopped , lowered, with the door handle, shaved. Thanks for looking! submitted by /u/UsefulBowler3477 [visit reddit] [comments ..read more