Polytech Forum » General Metalworking
40 FOLLOWERS
This section is for discussing general metalworking, which deals with all aspects of working with metal. This is an online community for engineers and metalworking enthusiasts.
Polytech Forum » General Metalworking
2y ago
Many years ago I looked at an aluminum body motorcycle trailer. It was at a run or a show. I don't recall exactly. There was a top hinged door that used no bolt/weld/rivet on hinge. One of th...... The post has 3 replies so far. Read more and discuss here ..read more
Polytech Forum » General Metalworking
2y ago
FRACK!!! FRACK! FRACK! FRACK! Mother fracking fracking frack!!! We have cancelled your order for the XXXXX XXX (000000000) because we are no longer able to fulfill it due to supply chain disrup...The post does not have replies yet. Start the discussion here ..read more
Polytech Forum » General Metalworking
2y ago
On Sun, 17 Apr 2022 21:35:24 GMT They are an odd shaped mower blade. If they look anything at all like this image I would try sharpening them first: https://www.tractorforum.com/threads/sears-sh...The post does not have replies yet. Start the discussion here ..read more
Polytech Forum » General Metalworking
2y ago
My project is to build one or two round bale horse feeders. These hay feeders will be loaded with rolls of hay 5 feet in Dia and 4 feet tall. I have not been able to locate the 5' rings so far and th...... The post has 1 replies so far. Read more and discuss here ..read more
Polytech Forum » General Metalworking
2y ago
I've got half a dozen old steel chemical barrels (they were used to ship Roundup) that have been rinsed out. I'd like to cut the top out of two or three of them to organize scrap metal. Wrought...... The post has 15 replies so far. Read more and discuss here ..read more
Polytech Forum » General Metalworking
2y ago
I'm working (in stages) on a big work bench and storage unit to go the full length of the back wall of my shop. I originally planned a single monolithic steel top bench 56 feet long. I've since...... The post has 4 replies so far. Read more and discuss here ..read more
Polytech Forum » General Metalworking
2y ago
I have a brown, double door, 4 burner Crown stove. The doors no longer have their springs and fall open. They are heavy and dangerous. Does anyone know where I can get springs for these doors? Thanks...... The post has 1 replies so far. Read more and discuss here ..read more
Polytech Forum » General Metalworking
2y ago
I need a brush for the motor in a Rigid-branded shopvac. It's 250 mils by 318 mils, and about an inch long with braided tail out the end. The holder has the spring so the brush does not need one. ...... The post has 10 replies so far. Read more and discuss here ..read more
Polytech Forum » General Metalworking
2y ago
Hi everyone just bought a Delta bench grinder a few weeks ago & to be honest was a bargain I think ?. The problem is I can find any information regarding the Delta grinder I got , the model number p...... The post has 1 replies so far. Read more and discuss here ..read more
Polytech Forum » General Metalworking
2y ago
I still have to bolt the intake on , motor mounts and some bracketry and I'll be ready to drop Mr Motor back into his home . The trans turned out to need a complete rebuild , got it back a coup...... The post has 5 replies so far. Read more and discuss here ..read more