![CNC Zone » MetalWorking](https://i1.feedspot.com/5392468.jpg?t=1650383626)
CNC Zone » MetalWorking
42 FOLLOWERS
CNC Zone is the largest forum for discussing CNC machining, woodworking, laser cutting, RFQs, and much more. This section of the forum is for discussing problems, tips, and techniques for machining metal, casting metals, bending, forging, extrusion techniques, and mold making.
CNC Zone » MetalWorking
1w ago
I've got an old Fanuc 30F red cap AC servo motor. I'd like to remove the brake, or at least the ..read more
CNC Zone » MetalWorking
1w ago
Centroid Acorn CNC Controller as shown in the photos - It works fine... $300 shipped to your door ..read more
CNC Zone » MetalWorking
1w ago
Oriental Motors model PKP299D63AA 3.35 in. NEMA 34 (85mm) 2-Phase Bipolar (Project left over ..read more
CNC Zone » MetalWorking
1w ago
Cut 1 sheet of EVA Boat Carpet on a CNC with it. Worked very well. This puts the Donek knife and ..read more
CNC Zone » MetalWorking
1w ago
I'm selling the parts I no longer use on my 1995 Milltronics Partner 1 series H. I have gone with a ..read more
CNC Zone » MetalWorking
2M ago
I have, Alphacam have not replied. XYZ says they don't modify or create posts ..read more
CNC Zone » MetalWorking
2M ago
alternatively you could message/call me on my mobile - +44 7476111558 All help would be greatly ..read more
CNC Zone » MetalWorking
2M ago
Hi, I did my homework:-) Unfortunately it is more complicated than I expected! I simply bought a ..read more