What are your experiences with Starline rifle brass? I've used their handgun brass to loads many, many thousands of rounds. I just ordered a 250 pack of 7mm-08 Rem a few days ago. It was priced very fairly, $129 with free shipping. Anything to look out for with their rifle brass ..read more

Does anyone have any experience with VV N150? It's supposed to be the most temperature stable of the VV rifle powders. It gives the second highest velocity in the 7mm-08 just behind VV N540. The 540 is a "high energy" powder. They use a nitro glycerin addition to get the extra energy. That comes at the cost of a much hotter flame and greatly reduced barrel life. I've been loading Varget in the 7-08 for a while, mainly because of it's tolerance to temperature changes. The problem with Varget... VihtaVuori N150 ..read more

New to reloading here. .308 Winchester. Cases are full length resized. My intentions were .002" off the shoulder. But I'm shooting a Thompson Center breech loader. So using a closing/non closing bolt isn't an option so I trimmed the cases to 2.015". Once fired factory ammo fired in this gun. Cases are 2.012-2.021. Cases longer than 2.015" I trimmed back. 1--i assume the shorter cases are still safe to fire as they have already been fired. Using the Hornady OAL gauge I am making contact... OAL questions ..read more

Ok. I'm loading 30-06 using new brass all within spec. 180gr jacketed soft point over h4350. Here's where I am sure I screwed up, set the oal. To match my grandfather's reloads that shot ok. I set it at 3.18, I used a new Winchester bonded that shot ok as a base line gauge setting and fine tuned from there. Now I looked at the load chart and it says 3.30 min. Oal. Do I have to pull bullets as I think this is unsafe pressure. Forgot 51 grains of powder ..read more

I have 80 7mm rem mag brass cases, 20 are primed. $65 obo, a little spring cleaning turned them up. Thanks for looking. Message me, I'm in Grand Blanc ..read more

Just curious.........is it still being made? Or did Hodgdon decide to ditch that one, too ..read more

We have over a 1000 once fired 300 mag casings and probably a couple of hundred 358. They belonged to my wife’s grandfather that worked for GM . Can you guys help with pricing for these and also if there is any interest in purchasing. We do not have any use for them . Thank you in advance Brad Peeden 336-430-4708 ..read more

Just a heads-up that I'm selling some surplus 30-cal bullets in the Hunting classifieds.... -NC ..read more

Harbor Freight has their Sonic Cleaner on sale for $69.99 May be worth checking it out ..read more

Just a heads-up that I'm selling some surplus 30-cal bullets in the Hunting classifieds.... -NC ..read more