I needed a digital sign holder for the work I do, so I designed this case. As you can see, you slide the digital sign into the grooves, and then in the back compartment is where you store the cable and the battery pack! Simply slap magnets on the back of the case if sticking to metal, and whala, you got a digital case holder. Questions? Ask away ..read more

Hi, I have Anet A8 Plus with Marlin 2 (after upgrade printed 5000 hours, no problem) and now it is doing something strange. Right now I am in 6th hour of 45 hours print and I do not know what to do. It started normally, but after 30 minutes I found out that 2 rows on the LCD display are displaying nonsense and now it looks like this. But it prints. Had someone experienced something similar ..read more

Things to check... 1. Retraction settings - have they changed/been reduced. 2. Axis screws/belts - any signs of becoming loose? 3. Has Ironing been added with odd settings in slicer? ... and looking at the picture again, is there anything hanging from the print head? Maybe an old bit of extruded filament that is scratching the surface? These are all generic things to check and not specific to your printer. Sometimes stuff happens where the cure is seemingly unrelated, I changed my hot end when my prints became poorer after trying loads of other things and the issue went away. Good luck ..read more

hi, my top surfaces went from printing almost perfect like the green circle shows on the below photo to printing rough and scratched top surfaces like the 2 black circles are showing, its only the top layer, everything prints fine until that last surface, is doing it with different filaments, my printer is the Bambu Lab P1S, how can I fix this, thanks a lot ..read more

1. Re-level your print bed. If you have an auto level, run it before a print just to be sure and see if that fixes the issue. 2. Increase you initial layer height to 0.32, and check your initial extruder speed. Mine was set to 100% so I changed it to 50% and had a significant change in bed adhesion. That was because the initial layer speed was at 50% and it was trying to extrude 100%. I don't know if the math is right on what I did but hit helped me. 3. Increase your nozzle and bed temp until you get a good adhesion. I get best results with PLA I use (mostly Hatchbox but I've been using Creali ..read more

I am having a consistent issue with the base of my prints not remaining on the base. The raft or bottom of the print will come loose from the plate during printing. Usually, not the entire print but on one side or another. The result is bent builds or failed prints. I am printing with PLA. Does anyone have any suggestions as to the cause ..read more

I'm using a Bambu P1S with Overture filament, default Overture preset. That sounds right. Probably just going too fast. Thank you ..read more

Hi! What printer and what filament are you using? It looks like under extrusion, your filament is not melting quick enough to the speed you are printing. Try to lower the speed you are printing Maf ..read more

A Christmas Story House. I recently stayed at this house and the Bumpass's House over the Thanksgiving Day Weekend 2023. I love this movie and I have spent hours trying to get a good print. I made all of the files separate (Old Mans car- Shed, tree, fence) and then added them all to make a scene. Once this house is shrunk down there are allot of imperfections. It prints fine at a larger size, but the smaller it got the more the resin had a hard time forming. I made allot of mistakes, I ended up tinkering with the resin settings and it prints fine now. I actually have a larger print with the ..read more

When printing the flat base is not 100% full and has lines in both directions. See pic please I'm at a loss in how to get rid of them ..read more